SH-01Dの取扱説明書・マニュアル [全198ページ 23.56MB]
SH-01D_J_OP_01.pdf
gizport - 2013-08-14
http://www.nttdocomo.co.jp/.../SH-01D_J_OP_01.pdf - 23.56MB
- キャッシュ
37106view
198page / 23.56MB
176SH-01D_J_10.fm[176/185]付録/索引?Changes or modifications not expressly approved by the manufacturer responsible for compliance could void the user's authority to operate the equipment.Information to UserThis equipment has been tested and found to comply with the limits of a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications.However, there is no gua rantee that interference will not occur in a particu lar installation; if this equipment does cause harmful interference to radio or television reception, which can be determined by turning th e equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:1. Reorient/relocate the receiving antenna.2. Increase the separation between the equipment and receiver.3. Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.4. Consult the dealer or an experienced radio/TV technician for help.FCC RF Exposure InformationYour handset is a radio transmitter and receiver.It is designed and manufactured not to exceed the emission limits for exposure to radio frequency (RF) energy set by the Federal Communications Commission of the U.S. Government.The guidelines are based on standards that were developed by independent s cientific organizations through periodic and thorough evaluation of scientific studies. The standards include a substantial safety margin designed to assure the safety of all persons, regardless of age and health.The exposure standard for wireless handsets employs a unit of measurement known as the Specific Absorption Rate, or SAR. The SAR limit set by the FCC is 1.6 W/kg.The tests are performed in positions and locations (e.g., at the ear and worn on the body) as required by the FCC for each model. The highest SAR value for this model handset when tested for use at the ear is 0.616 W/kg and when worn on the body, as described in this user guide, is 0.720 W/kg.Body-worn Operation; Thi s device was tested for typical body-worn operations with the back of the handset kept 1.0 cm from the body. To maintain compliance with FCC RF exposure requirements, use accessories that maintain a 1.0 cm separation distance between the user's body and the back of the handset. The use of belt clips, holsters and similar accessories shou ld not contain metallic components in its assembly.SH-01D_J.book 176 ページ 2012年8月31日 金曜日 午前9時17分
参考になったと評価
17人が参考になったと評価しています。
その他の取扱説明書
18884 view
18473 view
25846 view
496 view