FCC Radiation Exposure StatementCAUTION: The radiated output power of the Dell Wireless 5540 HSPA Mobile Broadband Mini-Card is farbelow the FCC radio frequency exposure limits. Nevertheless, the Dell Wireless 5540 Mobile BroadbandMini-Card should be used in such a manner that the potential for human contact during normal operationis minimized. Details of the authorized configurations can be found athttps://fjallfoss.fcc.gov/oetcf/eas/reports/GenericSearch.cfm by entering the FCC ID number on thedevice.CAUTION: This device has been evaluated for and shown compliant with the FCC RF exposure limits underportable exposure conditions (antennas are within 20 cm of a person's body) when installed in certainspecific OEM configurations. This device has also been evaluated and shown compliant with the FCC RFExposure limits under mobile exposure conditions (antennas are greater than 20cm from a person's body).Details of the authorized configurations can be found athttps://fjallfoss.fcc.gov/oetcf/eas/reports/GenericSearch.cfm by entering the FCC ID number on thedevice.Interference StatementThis device complies with Part 15 of the Federal Communications Commission (FCC) Rules. Operation is subject to thefollowing two conditions: (1) This device may not cause harmful interference, and (2) This device must accept anyinterference received, including interference that may cause undesired operation.This equipment has been tested to, and found to be within the acceptable limits for a Class B digital device, pursuant to part15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference when theequipment is operated in a residential environment. This equipment generates radio frequency energy and is designed for usein accordance with the manufacturer's user manual. However, there is no guarantee that interference will not occur in anyparticular installation. If this equipment causes harmful interference to radio or television reception, which can be determinedby turning the equipment off and on, you are encouraged to try to correct the interference by one or more of the followingmeasures:Reorient or relocate the receiving antennaIncrease the separation between the equipment and the receiverConnect the equipment into an outlet on a circuit different from that to which the receiver is connected
