sPIkeD foot for Carpeted floors (Silver RX6 & RX8 only)The Silver RX spiked foot encorporates a spike for use on carpeted loors and also, a soft polymer pad for use on wooden or tiled loors. Please ensure there are no hidden wires under the carpet that could be damaged by the spikes.The foot comes fully assembled for use on carpeted loors. All that is required is ixing into the plinth. This is achieved by screwing the feet fully into the 4-threaded insert in the underside of the plinth. If your carpet has a very thick pile, remove the soft polymer pad from the foot to ensure the spike goes right through the carpet into the loor. With great care turn your cabinet the right way up. Place the cabinet in your desired location, and check that it is level on all sides. If it is slightly off level, unscrew the spike at the lowest point and check again. Continue this process until the cabinet is fully level. Use the locking nut on the foot to ix the foot in place and to stop any unwanted vibrations. for wooden/Hard floors (Silver RX6 & RX8 only)For use on solid loors or where spikes are inappropriate, it is possible to use the foot without the spike insert. To use the foot in this manner carefully grip the knurled portion of the spike and rotate anti clockwise to unscrew the spike fully.You may ind it easier to irst remove the polymer pad so as to gain more purchase on the spike. The pad should be replaced before carrying out the levelling operation described above.Locking NutMain Threaded AssemblySpikePolymer Padmonitoraudio.co.uk 11Silver RX Manual.indd 11 03/06/2009 16:18:18
