1. 取扱説明書・マニュアル >
2. パソコン >
3. パソコン周辺機器 >
4. モニタ・ディスプレイ

ソニー モニタ・ディスプレイの取扱説明書・マニュアル [全76ページ 3.35MB]

Adjustment Using the Menus63 MARKER SETTINGT/C (time code) DISPLAY SETTINGSCREEN SAVER Sets the scre en saver function on or off.ON: If a still image is displayed for more than 10 minutes, the brightness of the screen is automatically decreased to reduce burn-in. The screen returns to normal brightness when you input an image to the unit or operate the buttons on the front panel of the unit. While the screen saver is activated, the LED of the selected input select button flashes. (To decrease the brightness of the LED, see "LED BRIGHTNESS" on page 62.) This is the factory setting.OFF: The screen saver function is deactivated.Submenu SettingMARKER ENABLE Selects ON to display the marker and OFF not to display.NoteWhen NATIVE is selected in the SCAN setting, the marker is not displayed.To display the marker, select a setting other than NATIVE.MARKER SELECT Selects the aspect ratio according to the film, when the frame of the film is displayed on the screen.When 16:9 aspect ratio is selected with the button which the aspect function is assignedYou can select from among 4:3, 15:9, 14:9, 13:9, 1.85:1, 2.35:1, 1.85:1 & 4:3 and OFF.When 4:3 aspect ratio is selected with the button which the aspect function is assignedYou can select 16:9 or OFF.CENTER MARKER Selects ON to display the center mark of the picture and OFF not to display.Submenu SettingMARKER ENABLE: xxxMARKER SELECT: xxxCENTER MARKER: xxSAFETY AREA: xxxMARKER LEVEL: xMARKER MAT: xxxUSER CONFIG - MARKER SETTINGSAFETY AREA Selects the safe area size for the aspect ratio determined by the button to which the aspect function is assigned. You can select from OFF, 80%, 85%, 88%, 90% and 93%.When the marker is displayed, the safe area for the marker is displayed.MARKER LEVEL Sets the luminance to display the MARKER SELECT, CENTER MARKER and SAFETY AREA. You can select between 1 and 2. When the setting is low, the marker appears dark.MARKER MAT Selects whether you put mat on the outside of the marker display.OFF: No mat is put.HALF: Gray mat is put.Submenu SettingT/C Selects ON to display the time code display and OFF not to display.FORMAT Sets the time code format.VITC: To display the time code in VITC format.LTC: To display the time code in LTC format.POSITION Sets the position of the time code display. You can select between 1 and 2.1: Top2: BottomTRANSPARENCY Selects BLACK or HALF (transparent) for the background of T/C display.BLACK: The background becomes black. Displayed image is hidden behind the background.HALF: The background becomes transparent. Displayed image appears under the T/C display.Submenu SettingT/C: xxxFORMAT: xxxPOSITION: xTRANSPARENCY: xxxxUSER CONFIG - T/C DISPLAY SETTING

このマニュアルの目次

Copyright © 2013 Gizport.jp All Rights Reserved.