1. 取扱説明書・マニュアル >
2. パソコン >
3. パソコン本体 >
4. ノートパソコン

DELL ノートパソコンの取扱説明書・マニュアル [全143ページ 7.49MB]

Back to Contents PageIntel AMT WebGUIThe Intel(R) AMT WebGUI is a Web browser-based interface for limited remote computer management. The WebGUI is oftenused as a test to determine if Intel AMT setup and configuration was performed properly on a computer. A successful remoteconnection between a remote computer and the host computer running the WebGUI indicates proper Intel AMT setup andconfiguration on the remote computer.The Intel AMT WebGUI is accessible from any Web browser, such as the Internet Explorer(R) or Netscape(R) applications.Limited remote computer management includes:Hardware inventoryEvent loggingRemote computer resetChanging of network settingsAddition of new usersWebGUI support is enabled by default for SMB setup and configured computers. WebGUI support for Enterprise setup andconfigured computers is determined by the setup and configuration server. Information on using the WebGUI interface isavailable on the Intel AMT website.An older version of the WebGUI interface is available at Intel AMT Small Business Administrator's Guide under Using the WebBrowser Interface on page 4.Follow the steps below to connect to the Intel AMT WebGUI on a computer that has been configured and set up :1. Turn on an Intel AMT capable computer that has completed Intel AMT setup and configuration.2. Launch a Web browser from a separate computer, such as a management computer on the same subnet as the IntelAMT computer.3. Connect to the IP address specified in the MEBx and port of the Intel AMT capable computer. (example:http://ip_address:16992 or http://192.168.2.1:16992 )By default, the port is 16992. Use port 16993 and https:// to connect to the Intel AMT WebGUI on a computerthat has been configured and set up in the Enterprise mode.If DHCP is used, then use the fully qualified domain name (FQDN) for the ME. The FQDN is the combination ofthe host name and domain. (example: http://host_name:16992 or http://system1:16992 )The management computer makes a TCP connection to the Intel AMT capable computer and accesses the top levelIntel AMT-embedded Web page within the Management Engine of the Intel AMT capable computer.Type the username and password. The default username is admin and the password is what was set during Intel AMTsetup in the MEBx. Review the computer information and make any necessary changes. You can change the MEBxpassword for the remote computer in the WebGUI. Changing the password in the WebGUI or a remote console resultsin two passwords. The new password, known as the remote MEBx password, only works remotely with the WebGUI orremote console. The local MEBx password used to locally access the MEBx is not changed. You have to remember boththe local and remote MEBx passwords to access the computer MEBx locally and remotely. When the MEBx password isinitially set in Intel AMT setup, the password serves as both the local and remote password. If the remote password ischanged, then the passwords are out of sync. Select Exit.Back to Contents Page

このマニュアルの目次

Copyright © 2013 Gizport.jp All Rights Reserved.