Z4 LEDの解決方法
Q&A
取扱説明書・マニュアル (文書検索対応分のみ)
"LED"1 件の検索結果
"LED"20 - 30 件目を表示
Driving42You accelerate from higher gears, e.g. dur-ing passing, by downshifting manually.In the following situations, the SMG in the sequential mode assists you:>The transmission will only execute upshifts and downshifts that will result in an appropriate combination of vehi-cle speed and engine rpm. For instance, downshifts that would result in excessive engine speed cannot be executed>During a stop the gearbox is automati-cally downshifted into first gear>Shortly before a gear-dependent mini-mum speed is...
Replacement procedures90Front turn signal indicators21 watt bulb1.Insert a Phillips-head screwdriver from the onboard toolkit into the appropriate opening, arrows 12.Turn the screwdriver to the left, arrows 23.Use the Phillips-head screwdriver to pull out the entire bulb holder4.Replace the bulb5.Install in the reverse order.Side turn signal indicators 5 watt bulb1.Turn the lamp to the left and remove2.Apply gentle pressure to the bulb while turning it to the left to remove3.Install in the reverse order.Tai...
Controls 61ReferenceAt a glanceDriving tipsCommunicationsNavigationEntertainmentMobilityDeactivating intermittent wipe or rain sensorPress the button again, arrow 3. The LED goes out.Deactivate the rain sensor before enter-ing an automatic car wash. Failure to do so could result in damage caused by undesired wiper activation.<Cleaning windshield and headlamps*Pull the lever, arrow 4.Washer fluid is sprayed onto the windshield and the wipers are operated for a short time.When the vehicle lighting system ...
Controls 97ReferenceAt a glanceDriving tipsCommunicationsNavigationEntertainmentMobilitySwitching the cooling function on andoffThe cooling function cools and dehumidifies the incoming air before reheating it as required, according to the temperature set-ting. This function is only available while the engine is running.The cooling function helps prevent condensa-tion on the windows or removes it quickly.Depending on the weathe r, the windshield may fog over briefly when the engine is started.The cooling fu...
Transporting children safely48Transporting children safelyThe right place for childrenDo not leave children unattended in the vehicle; otherwise, they could endanger themselves and/or other persons by opening the doors, for example. <Children on the passenger seatAlways transport children under the age of 13 or smaller than 5 ft/150 cm in a child restraint system suitable for their age, weight and size, and with the passenger airbag deacti-vated. Otherwise, there is an increased risk of injury in the even...
Driving60Triple turn signal activationPress the lever as far as the resistance point.The turn signals flash once.You can set whether it should flash once or three times when activated.1. Press the button.2."Settings"3."Lighting"4."Triple turn signal"The setting is stored for the remote control currently in use.Wiper system1Switching on wipers2Switching off wipers or brief wipe3Activating/deactivating intermittent wipe or rain sensor*4Cleaning windshield and headlamps5Setting speed for intermittent wipe, or...
ReferenceAt a glanceControlsDriving tipsMobility 43Deactivating the Sport programPress the SPORT button again.The LED in the button goes out.Acceleration assistant with SMGThe acceleration assistant permits opti-mum racing-style acceleration on skid-resistant roads.Do not use the acceleration assistant too often, as this could cause the vehicle's parts to wear prematurely. <1.Activate the Sport program2.Press and hold the DSC button for more than three seconds, refer to page 533.Depress the accelerator all ...
Seat and mirror memory*General informationTwo different driver's seat and exterior mirrorpositions can be stored and retrieved for eachremote control.Settings for the backrest width and lumbar sup‐port are not stored.Storing1. Switch on the radio ready state or the igni‐tion, refer to page 50 .2. Adjust the seat and exterior mirrors to thedesired positions.3. Press the button. The LED in thebutton lights up.4.Press the desired memory button 1 or 2: theLED goes out.If the M button is pressed accidentally:P...
3. "Pathway light.: s"4. Set the duration.The setting is stored for the remote control cur‐rently in use.Automatic headlamp controlSwitch position : the low beams are switchedon and off automatically depending on the am‐bient light, e.g., in tunnels, in twilight or if thereis precipitation. The LED next to the symbollights up.A blue sky with the sun low on the horizon cancause the lights to be switched on.Personal responsibilityThe automatic headlamp control cannotserve as a substitute for your personal ...
Adjustments44Storing1.Switch on radio readiness or the ignition, refer to page50.2.Adjust the seat and exterior mirrors to the desired positions.3.Press the button.The LED in the button lights up.4.Press the desired memory button 1 or 2: the LED goes out.The driver's seat and exterior mirror posi-tions are stored for th e remote control cur-rently in use.Call-upDo not call up memory while you are driv-ing; otherwise, unexpected seat move-ment could result in an accident. <Convenience mode1.Unlock and ope...
- 1
