ログイン
質問する
XPS M1210
x
Gizport

XPS M1210 の使い方、故障・トラブル対処法

XPS M1210の使い方、故障・トラブル対処法 »

  • Q&A

  • 取扱説明書・マニュアル (文書検索対応分のみ)

　
20 - 30 件目を表示
Dell™ XPS™ M1210 Service Manual Before You BeginCoin-Cell BatteryOptical DrivePalm RestHard DriveModemMemory Module(s)Processor ModuleHinge CoverFanKeyboardThermal-Cooling AssemblyMini-CardsHard Drive Bay/ExpressCard Cage AssemblyInternal Card With Bluetooth® Wireless TechnologySystem BoardDisplayFlashing the BIOSCamera (Optional)Pin Assignments for I/O Connectors  Notes, Notices, and CautionsNOTE: A NOTE indicates important information that helps you make better use of your computer.NOTICE: A NOTICE indica...
Back to Contents Page  Before You BeginDell™ XPS™ M1210 Service Manual  Recommended Tools  Turning Off Your Computer  Before Working Inside Your ComputerThis section provides procedures for removing and installing the components in your computer. Unless otherwise noted, each procedure assumes that thefollowing conditions exist:l You have performed the steps in Turning Off Your Computer and Before Working Inside Your Computer.l You have read the safety information in the Dell™ Product Information Guide.l A c...
1battery-bay latch release2battery bay3SIM card connector4metal tabs (2)5SIM card  NOTICE: To protect the SIM card from electrostatic discharge (ESD), do not touch the SIM card connector. Also, take care when removing the card toslide the card completely out of the metal tabs before lifting the card out of the slot. The card is brittle and may easily break otherwise.2. With the cut-off corner on the card facing away from the card slot, insert the SIM card into the slot so that it slides under the metal tabs...
Back to Contents Page  ModemDell™ XPS™ M1210 Service Manual  Removing the Modem  Replacing the Modem Removing the Modem CAUTION: Before you begin the following procedure, follow the safety instructions in the Product Information Guide.NOTICE: To avoid electrostatic discharge, ground yourself by using a wrist grounding strap or by periodically touching an unpainted metal surface (suchas the back panel) on the computer.NOTICE: To help prevent damage to the system board, remove the main battery (see Before Wor...
Back to Contents Page  FanDell™ XPS™ M1210 Service Manual CAUTION: Before you begin the following procedure, follow the safety instructions in the Product Information Guide.NOTICE: To avoid electrostatic discharge, ground yourself by using a wrist grounding strap or by periodically touching an unpainted metal surface (suchas the back panel) on the computer.NOTICE: To help prevent damage to the system board, remove the main battery (see Before Working Inside Your Computer) before working inside thecomputer.1...
1M2.5 x 8-mm screws (4)1touch-pad connector11.2captive screw2tabs (4) Lift the palm rest from the computer base:a. Raise the palm rest at the back of the computer.NOTE: If you were unable to disconnect the touch-pad connector with the palm rest in place (step 9), reach under the palm rest to disconnect thetouch-pad connector from the system board.b. Slide the palm rest toward the front of the computer to release it from the four small tabs along the front of the computer base, and remove itfrom the computer...
Back to Contents Page  Pin Assignments for I/O ConnectorsDell™ XPS™ M1210 Service Manual  USB Connector  Video Connector  S-Video TV-Out Connector  IEEE 1394 Connector USB Connector  Pin Signal1USB5V+2USBP–3USBP+4GND Video Connector    Pin Signal Pin Signal1CRT_R 95V+2CRT_G 10GND3CRT_B 11MONITOR_DETECT–4NC12DDC_DATA5GND13CRT_HS6GND14CRT_VS7GND15DDC_CLK8GND   S-Video TV-Out Connector S-Video  Pin Signal1GND
1WLAN card2antenna cable connectors (2)b. Release the WLAN card by pushing the metal securing tabs toward the back of the computer until the card pops up slightly.c. Lift the WLAN card out of its system board connector.1metal securing tabs (2)NOTICE: The connectors are keyed to ensure correct insertion. If you feel resistance, check the connectors and realign the card.4. Install the replacement WLAN card:NOTICE: Do not install a Mobile Broadband card in the WLAN card slot.a. Insert the WLAN card connector i...
Back to Contents Page  Hard DriveDell™ XPS™ M1210 Service Manual  Removing the Hard Drive  Replacing the Hard Drive  Returning a Hard Drive to Dell Removing the Hard Drive CAUTION: If you remove the hard drive from the computer when the drive is hot, do not touch the metal housing of the hard drive. CAUTION: Before you begin the following procedure, follow the safety instructions in the Product Information Guide.NOTICE: To help prevent damage to the system board, remove the main battery (see Before Working ...
2GND3DLUMA-L4DCRMA-L Composite Video  PinSignal5NC6DCMPS-L7GND IEEE 1394 Connector  Pin Signal1TPB–2TPB+3TPA–4TPA+Back to Contents Page 

この製品について質問する