XPS M1210 Dellの解決方法

Back to Contents Page  Before You BeginDell™ XPS™ M1210 Service Manual  Recommended Tools  Turning Off Your Computer  Before Working Inside Your ComputerThis section provides procedures for removing and installing the components in your computer. Unless otherwise noted, each procedure assumes that thefollowing conditions exist:l You have performed the steps in Turning Off Your Computer and Before Working Inside Your Computer.l You have read the safety information in the Dell™ Product Information Guide.l A c...

Back to Contents Page  Hard DriveDell™ XPS™ M1210 Service Manual  Removing the Hard Drive  Replacing the Hard Drive  Returning a Hard Drive to Dell Removing the Hard Drive CAUTION: If you remove the hard drive from the computer when the drive is hot, do not touch the metal housing of the hard drive. CAUTION: Before you begin the following procedure, follow the safety instructions in the Product Information Guide.NOTICE: To help prevent damage to the system board, remove the main battery (see Before Working ...

 Replacing the Hard Drive1. Place the new drive in the hard drive carrier from which you removed the original hard drive.NOTICE: Use firm and even pressure to slide the drive into place. If you use excessive force, you may damage the connector.2. Slide the drive into the bay until it is fully seated.3. Replace and tighten the four M3 x 3-mm hard-drive screws.4. If you have installed a replacement hard drive, reinstall the Microsoft® Windows® operating system and the drivers for the new hard drive. Forinstru...

Back to Contents Page  Camera (Optional)Dell™ XPS™ M1210 Service Manual  Removing the Camera  Replacing the Camera Removing the Camera CAUTION: Before you begin the following procedure, follow the safety instructions in the Product Information Guide.NOTICE: To avoid electrostatic discharge, ground yourself by using a wrist grounding strap or by periodically touching an unpainted metal surface (suchas the back panel) on the computer.NOTICE: To help prevent damage to the system board, remove the main battery ...

1securing clips (2)c. Use your fingertips to carefully spread apart the securing clips on each end of the memory module connector until the module pops up.d. Remove the module from the connector at a 45-degree angle. Replacing the Memory Module(s)NOTE: If a memory module is not installed properly, the computer does not boot properly. No error message indicates this failure.1. Ground yourself and install the new memory module:a.2. Align the notch in the module edge connector with the tab in the connector slo...

Back to Contents Page  Memory Module(s)Dell™ XPS™ M1210 Service Manual  Removing the Memory Module(s)  Replacing the Memory Module(s) Removing the Memory Module(s) CAUTION: Before you begin the following procedure, follow the safety instructions in the Product Information Guide.NOTICE: To avoid electrostatic discharge, ground yourself by using a wrist grounding strap or by periodically touching an unpainted metal surface (suchas the back panel) on the computer.NOTICE: To help prevent damage to the system bo...

Back to Contents PageDell™ XPS™ M1210 Service ManualNOTE: A NOTE indicates important information that helps you make better use of your computer.NOTICE: A NOTICE indicates either potential damage to hardware or loss of data and tells you how to avoid the problem.CAUTION: A CAUTION indicates a potential for property damage, personal injury, or death.For a complete list of abbreviations and acronyms, see "Glossary" in the Owner's Manual.If you purchased a Dell™ n Series computer, any references in this docume...