Precautions with regard to safetyImportant Information6 - ENGLISHWARNINGPOWER The wall outlet or the circuit breaker shall be installed near the equipment and shall be easily accessible when problems oc-cur. If the followings problems occur, cut off the power supply immediately.Continued use of the projector in these conditions will result in ire or electric shock.If foreign objects or water get inside the projector, zcut off the power supply.If the projector is dropped or the cabinet is broken, zcut off the power supply.If you notice smoke, strange smells or noise com - zing from the projector, cut off the power supply.Please contact an Authorized Service Center for repairs, and do not attempt to repair the projector yourself.During a thunderstorm, do not touch the projector or the cable.Electric shocks can result.Do not do anything that might damage the power cord or the power plug.If the power cord is used while damaged, electric shocks, short-circuits or ire will result.Do not damage the power cord, make any modii - zcations to it, place it near any hot objects, bend it excessively, twist it, pull it, place heavy objects on top of it or wrap it into a bundle.Ask an Authorized Service Center to carry out any repairs to the power cord that might be necessary.Insert the power plug securely into the wall outlet.If the plug is not inserted correctly, electric shocks or overheating will result.Do not use anything other than the provided power zcord.Do not use plugs which are damaged or wall outlets zwhich are coming loose from the wall.Clean the power plug regularly to prevent it from becoming covered in dust.Failure to observe this will cause a ire.If dust builds up on the power plug, the resulting zhumidity can damage the insulation.If not using the projector for an extended period of ztime, pull the power plug out from the wall outlet.Pull the power plug out from the wall outlet and wipe it with a dry cloth regularly.Do not handle the power plug with wet hands.Failure to observe this will result in electric shocks.Do not overload the wall outlet.If the power supply is overloaded (ex., by using too many adapters), overheating may occur and ire will result.ON USE/INSTALLATION Do not place liquid containers on top of the projector.If water spills onto the projector or gets inside it, ire or electric shocks will result.If any water gets inside the projector, contact an Authorized Service Center.Do not place the projector on soft materi -als such as carpets or sponge mats.Doing so will cause the projector to overheat, which can cause burns, ire or damage to the projector.Do not set up the projector in humid or dusty places or in places where the pro -jector may come into contact with oily smoke or steam, ex a bathroom.Using the projector under such conditions will result in ire, electric shocks or components deterioration. Components deterioration (such as ceiling mount brackets) may cause the projector which is mounted on the ceiling to fall down.Do not install this projector in a place which is not strong enough to take the full weight of the projector or on top of a surface which is sloped or unstable.Failure to observe this will cause projector to fall down or tip over the projector, and severe injury or damage could result.Do not place another projector or other heavy objects on top of the projector.Failure to observe this will cause the projector to become unbalanced and fall, which could result in damage or injury. The projector will be damaged or deformed.Installation work (such as ceiling sus -pension) should only be carried out by a qualiied technician.If installation is not carried out and secured correctly it can cause injury or accidents, such as electric shocks.Do not use anything other than an Authorized ceil - zing mount bracket.Do not cover the air inlet port or the air outlet port.Doing so will cause the projector to overheat, which can cause ire or damage to the projector.Do not place the projector in narrow, badly venti- zlated places such as closets or bookshelves.Do not place the projector on cloth or papers, as zthese materials could be drawn into the air inlet port .Do not place your hands or other objects close to the air outlet port.Doing so will cause burns or damage your hands or other objects.Heated air comes out of the air outlet port. Do not zplace your hands or face, or objects which cannot withstand heat close to this port.Precautions with regard to safety
