GL2250の取扱説明書・マニュアル [全47ページ 3.15MB]
lcd_monitor_um_user_manual_20130516_104052g(l)50se...
ftp://220.228.13.50/.../lcd_monitor_um_user_manual_20130516_104052g(l)50se... - 3.15MB
- キャッシュ
29034view
47page / 3.15MB
46 Troubleshooting TroubleshootingFrequently asked questions (FAQ)The image is blurred:Read the instructions on the link "Adjusting the Screen Resolution" on the CD, and then select the correct resolution, refresh rate and make adjustments based on these instructionsHow do you use a VGA extension cable?Remove the extension cable for the test. Is th e image now in focus? If not, optimize the image by working through the inst ructions in the "Adjusting the refresh rate" section on the link "Adjusting the Screen Resolution". It is normal for blurring to occur due to conduction losses in extension cables. You can minimize these losses by us ing an extension cable with better conduction quality or with a built-in booster.Does the blurring only occur at resolutions lower than the native (maximum) resolution?Read the instructions on the link "Adjus ting the Screen Resolution" on the CD. Select the native resolution.Pixel errors can be seen:One of several pixels is permanently black, on e or more pixels are permanently white, one or more pixels are permanently re d, green, blue or another color.* Clean the LCD screen.* Cycle power on-off.* These are pixels that are permanently on or of f and is a natural defect that occurs in LCD technology.The image has a faulty coloration:It has a yellow, blue or pink appearance.Select MENU > PICTURE > Color > Reset Color , and then choose " YES " in the " Caution " message box to reset the color settings to the factory defaults. If the image is still not correct and the OSD also has faulty coloration, this means one of the three primary colors is missing in the signal input. Now check the signal cable connectors. If any pin is bent or broken off, please contact your dealer to get necessary support.No image can be seen:Is the prompt on the display illuminated in green?If the LED is illuminated in green and there is a message "Out of Range " on the screen, this means you are using a display mode that this monitor does not support, please change the setting to one of the supported mode. Please read the "Preset display modes" section from the link "Adjusting the Screen Resolution". Faint shadow from the static image displayed is visible on the screen:* Activate the power management function to le t your computer and monitor go into a low power "sleep" mode when not actively in use.* Use a screensaver to prevent the occurrence of image retention.
参考になったと評価
29人が参考になったと評価しています。
この取扱説明書が関連付けられている製品