UKDEDK9JP3.1 DALI ZENSOR 1the speaker can be positioned on a stand/shelf or hung on a wall using the integrated wall bracket. If positioned on a stand or shelf, the enclosed rubber bumpers can be mounted under the speaker for stable and vibration free positioning, see Figure 3A. If hung on a wall, mount thebumpers on the rear edges of the speakers, see Figure 3B. the speakers are hung on a wall using one screw mounted in the wall. the screw must it the wall bracket on the rear side of the speaker, see Figure 3c. 3.2 DALI ZENSOR 5 and 7 the speakers are designed to stand on the loor. ZENSOR 5 and 7 can be used with spikes or rubber bumpers under the speakers, see Figure 3D/E. Be careful not to over tighten the locking nuts. Spikes or rubber bumpers can improve the sound quality. You can try both to hear what gives the best sound quality in your setup. Please be aware, that spikes may damage the loor, if it is not protected by e.g. coins under the spikes.3.3 DALI ZENSOR VOKALZENSOR VOKAL is the dedicated centre channel and has been specially designed to be positioned close to the large surface of the tV screen. You can place it above or below the screen, on a stand or on a shelf. We recommend itting the enclosed bumpers to ensure a stable, vibration-free setup (see Figure 3F).4.0 CONNECTIONcorrect, tight connections to your ampliier are extremely important for your listening experience. Always use cables of the same type and length for left and right channels. We recommend using special speaker cables from DALI, available from your dealer. connection in correct phase is a detail that is often ignored. the red (+) terminal of the ampliier must be connected to the red (+) terminal of the loudspeaker. the black (-) terminal of the ampliier must be connected to the black (-) terminal of the loudspeaker (see igure 4). Even a single loudspeaker connected out-of-phase in a stereo or surround installation will make the bass weaker and the stereo image unfocused.For the optimal listening experience, the right loudspeaker (as seen from the listening position) must be connected to the ampliier output terminals marked “R” or “Right”. the left loudspeaker must be connected to the ampliier output terminals marked “L” or “Left”.NOTE: Before connecting cables or changing any connections, ALWAYS turn off your ampliier. NOTE: Make sure that the bare conductors are tightly gripped by the terminals with no loose wires which could cause a short circuit and damage the ampliier (see Figure 5).NOTE: If you are using DALI ZENSOR in a surround system, follow the instructions included with your surround ampliier.
