5
00152.0210.v1.ALLRoomba.Manual.EN.pdf
moreau1996 - 2013-08-15
http://www.irobot.com/.../00152.0210.v1.ALLRoomba.Manual.EN.pdf - 4.66MB - キャッシュ
33092view
36page / 4.66MB
26 iRobot Roomba 500 Series TroubleshootingRoomba will tell you something is wrong with a two-tone “uh-oh” sound followed by a series of beeps or a narrated voice. The troubleshooting light will also blink. Refer to the chart below to resolve Roomba’s problem. If the problem is not resolved, visit www.irobot.com/support. Runtime ErrorsRoomba beeps...Or Roomba says…. Likely cause What to do1 beepError 1 ...Roomba is stuck with a wheel hanging down or Roomba is stuck. Ensure Roomba’s wheels are irmly on the loor. Start Roomba in a new location. 2 beeps Error 2 ...Roomba’s main brushes cannot turn. Remove and clean Roomba’s brushes. 5 beepsError 5 ...Roomba’s side wheel is stuck. Clean hair and debris from Roomba’s side wheels. Push them in and out and conirm that they both turn freely. Start Roomba in a new location.6 beepsError 6 ...Roomba’s cliff sensors are dirty or Roomba is stuck hanging over a cliff. Wipe Roomba’s cliff sensors with a dry cloth. Start Roomba in a new location.7 beeps Error 7 ...Roomba’s side wheel is stuck.Clean Roomba’s side wheels of hair and debris. Push them in and out and conirm that they both turn freely. Start Roomba in a new location.8 beepsRoomba’s front wheel is stuck or Roomba is stuck. Remove and clean hair and debris from Roomba’s front wheel. Start Roomba in a new location.9 beeps Error 9 ...Roomba’s bumper is compressed or the bumper sensor is dirty.Briskly tap Roomba’s bumper 10-20 times to dislodge any debris that may be trapped under the bumper. Error 10 ...Roomba’s side wheel is stuck or its bumper is not registering obstacles.If Roomba is circling in place, clean Roomba’s side wheels of hair and debris. Push them in and out and conirm that they both turn. If not circling in place, Roomba may be in an extremely large room. Use a Virtual Wall to create a smaller cleaning area.Tip : To repeat Roomba's error message, press the "clean" button.
