CTの取扱説明書・マニュアル [全40ページ 1.49MB]
sec_03-07.pdf
http://drivers.lexus.com/.../sec_03-07.pdf - 1.49MB
- キャッシュ
3575view
40page / 1.49MB
4693-7. Other interior features3Interior featuresCT200h_U (OM76040U)■Programming a rolling code system (for U.S.A. owners)If your device is rolling code eq uipped, follow the steps under theheading "Programming HomeLink(R)" before proceeding with thesteps listed below.Locate the training button* on the ceiling mounted garage dooropener motor. The exact location and color of the button mayvary by brand of garage door opener motor.Refer to the operation manual supplied with the garage door openerfor the location of the training button*.Press the training button *.Following this step, you have 30 se conds in which to initiate step 3below.Press and hold the vehicle's programmed HomeLink(R) button for2 seconds and release it. Repeat this step once again. The garagedoor may open.If the garage door opens, the programming process is complete. If thedoor does not open, press and release the button a third time. This thirdpress and release will complete the programming process by openingthe garage door.The ceiling mounted garage door op ener motor should now recognizethe HomeLink(R) signal and operate the garage door.Repeat the steps above to prog ram another rolling code systemfor any of the remaining HomeLink(R) buttons.*: Names such as "learn", "smart" or others vary according to manufac-turer.STEP 1STEP 2STEP 3STEP 4
参考になったと評価
3人が参考になったと評価しています。
その他の取扱説明書
39918 view
2014 view
17408 view
752 view
8770 view
もっと見る