GSの取扱説明書・マニュアル [全36ページ 7.19MB]
sec_03_07.pdf
http://drivers.lexus.com/.../sec_03_07.pdf - 7.19MB
- キャッシュ
2866view
36page / 7.19MB
4133-7. Other interior features3Interior featuresGS_G_U (OM30C80U)June 29, 2011 10:21 am■ Programming a Rolling Code systemIf your device is Rolling Code equipped, follow the steps under the heading "Programming the HomeLink(R)" before proceeding with the steps listed below.Locate the learn button on the ceiling mounted garage door opener motor. The exact location and color of the button may vary by brand of garage door opener motor.Refer to the operation manual supplied with the garage door opener motor for the location of the learn button.Press the learn button.Following this step, you have 30 se conds in which to initiate step 3 below.Press and hold the vehicle's programmed HomeLink(R) button for 2 seconds and release it. Repeat this step once again. The garage door may open.If the garage door opens, the programming process is complete. If the door does not open, press and release the button a third time. This third press and release will complete the programming process by opening the garage door.The ceiling mounted garage door opener motor should now recognize the HomeLink(R) transceiver and operate the garage door.Repeat the steps above to program another rolling code system for any of the remaining HomeLink(R) buttons.STEP 1STEP 2STEP 3STEP 4
参考になったと評価
3人が参考になったと評価しています。
その他の取扱説明書
14551 view
1704 view
7252 view
1579 view
12497 view
もっと見る