MINIの取扱説明書・マニュアル [全172ページ 1.90MB]
ownersmanual2007convertible.pdf
gizport - 2013-09-04
http://libraryofmotoring.info/.../ownersmanual2007convertible.pdf - 1.90MB
- キャッシュ
42627view
172page / 1.90MB
88INTEGRATED UNIVERSAL REMOTE CONTROL*The conceptThe integrated universal remote control takes the place of up to three different con-trol devices for different radio-remote-con-trolled systems such as gate openers and household alarm systems. The integrated universal remote control detects and learns the signal transmitted by the original con-trol device.The signal of an original control device can be programmed onto one of the three memory buttons1. The system in question can then be operated by means of the pro-grammed memory button1. Signal trans-mission is indicated by LED 2.If you decide to sell your vehicle one day, in the interest of your own security, remem-ber to delete the programs before the vehi-cle leaves your possession, refer to page 89 .While programming is in progress and before operating any pro-grammed system by remote control using the integrated universal remote control, make sure that the movement area of the system in question is clear of people, ani-mals and inanimate obstructions, in order to avoid possible injury or damage. Also comply with the safety precautions issued for the original control device. <Checking compatibilityIf this symbol is shown on the pack-aging or in the operating instruc-tions of the original control device, it is safe to assume that the remote-con-trolled system is compatible with the inte-grated universal remote control.If you have any additional question, please contact your MINI Dealer or call: 1-800-355-3515.You can find more information on the Internet at:www.miniusa.com orwww.homelink.com.HomeLink is a registered trademark of Johnson Controls, Inc. <Programming 1 Memory buttons2LEDFixed-code control device 1. Switch on the ignition2. For first-time start-up: press both outer buttons 1 for approx. 20seconds until LED2 flashes. This clears all three mem-ory buttons 13. Hold the original control device approx. 2 to 8in/5 to 20cm away from memory buttons1.The required distance between the control device and memory buttons1 may vary, depending on the system of the original control device in question. <
参考になったと評価
9人が参考になったと評価しています。
その他の取扱説明書
32724 view
11841 view
3489 view
28475 view
36650 view
もっと見る