MINIの取扱説明書・マニュアル [全160ページ 2.63MB]
ownersmanual2009hardtop.pdf
gizport - 2013-09-04
http://libraryofmotoring.info/.../ownersmanual2009hardtop.pdf - 2.63MB
- キャッシュ
40298view
160page / 2.63MB
REFERENCE AT A GLANCE CONTROLS DRIVING TIPS MOBILITY 121Preparing for a tire changeObserve the safety precautions regarding flat tires on page117.<Additional safety measures when chang-ing tires: Only change the tire when parked on a surface that is level, firm and not slippery.The vehicle or the jack could slip sideways on soft or slippery support surfaces, such as snow, ice, flagstones, etc. Do not use a wooden block or similar object as a support base for the jack, as this would prevent it from extending to its full support height and reduce its load-carrying capacity. Do not lie under the vehicle or start the engine when the vehicle is supported by the jack; other-wise there is a risk of fatal injury. <1.Place the foldable chock* behind the front wheel on the other side of the vehicle or in front of the wheel if the vehicle is on an incline. If the wheel is changed on a surface with a more severe slope, take additional precautions to secure the vehicle from roll-ing.2.Uncover the lug bolts if necessary.If the wheel is equipped with a hub cover, pry it off using the screwdriver from the tire change kit.3.Loosen the lug bolts by a half turn.Jacking up the vehicleThe vehicle jack is designed for changing wheels only. Do not attempt to raise another vehicle model with it or to raise any load of any kind. To do so could cause accidents and personal injury.<1.Place the jack at the jacking point closest to the wheel.The jack base must be perpendicular to the surface beneath the jacking point.2.During jacking up, insert the jack head in the square recess of the jacking point.3.Jack the vehicle up until the wheel you are changing is raised off the ground.Mounting the space-saver spare tire1.Unscrew the lug bolts and remove the wheel.2.Remove accumulations of mud or dirt from the mounting surfaces of the wheel and hub. Clean the lug bolts.3.Lift the new wheel into place.4.Screw at least two lug bolts finger-tight into opposite bolt holes.5.Screw in the remaining bolts.6.Tighten all the lug bolts firmly in a diagonal pattern.7.Lower the vehicle.8.Remove the jack.Tightening the lug boltsTighten the lug bolts in a diagonal pattern.Immediately have the wheels checked with a calibrated torque wrench to ensure that the lug bolts are firmly seated. Otherwise, incorrectly tightened lug bolts can present a safety hazard.<Tightening torque: 103.3 lb ft or 140 Nm.Replace the defective tire as soon as possible and have the new wheel/tire assembly bal-anced.
参考になったと評価
10人が参考になったと評価しています。
その他の取扱説明書
33129 view
11941 view
43060 view
3554 view
28697 view
もっと見る