MINIの取扱説明書・マニュアル [全174ページ 2.96MB]
ownersmanual2010hardtopconvertible.pdf
gizport - 2013-09-05
http://libraryofmotoring.info/.../ownersmanual2010hardtopconvertible.pdf - 2.96MB
- キャッシュ
6785view
174page / 2.96MB
Replacing components126When working on electrical systems, always begin by switching off the con-sumer in question; otherwise, short circuits could result. To avoid possible injury or equip-ment damage when replacing bulbs, observe any instructions provided by the bulb manufac-turer.<Caring for headlamps, refer to page 122.For any bulb replacement not described below, contact a MINI dealer or a work-shop that has specially trained personnel work-ing in accordance with the specifications of the MINI manufacturer. <For checking and adjusting headlamp aim, please contact your MINI dealer. <Light-emitting diodes LEDsLight-emitting diodes installed behind translu-cent lenses serve as the light sources for many of the controls and displays in your vehicle. These light-emitting diodes are related to conven-tional laser diodes, and legislation defines them as Class 1 light-emitting diodes.Do not remove the covers or expose the eyes directly to the unfiltered light source for several hours; otherwise, this could cause irritation of the retina. <Headlight glass lensIn cool or humid weather, condensation may occur on the interior of outside lights. The con-densation disappears a short time after the light is switched on. Headlight glass lenses do not need to be replaced. If a lot of moisture is present, e.g. water droplets in the light, have them checked by your service center.Xenon lamps*The service life of these bulbs is very long and the probability of failure very low, provided that they are not switched on and off an excessive number of times. If a xenon lamp fails neverthe-less, switch on the fog lamps and continue the journey with great care, provided that local leg-islation does not prohibit this.Have any work on the xenon lamp system, including bulb replacement, carried out only by a MINI dealer or a workshop that has specially trained personnel working in accor-dance with the specifications of the MINI manu-facturer. Due to high voltage, there is a risk of fatal injury if work on the xenon lamps is carried out improperly.<Halogen low beams and high beamsH13 bulb, 60/55 wattsThe H13 bulb is pressurized. Therefore, wear safety glasses and protective gloves. Otherwise, there is a risk of injury if the bulb is damaged.<Be careful when installing the cover; oth-erwise, leaks could occur and cause dam-age to the headlamp system. <Accessing the lamp from the engine compartmentThe low-beam/high-beam bulb can be changed from the engine compartment.Removing the cover:1.Press the tab.2.Flip open the cover and take it out of the holder.Follow the same steps in reverse order to reat-tach the cover.Be careful when installing the cover; oth-erwise, leaks could occur and cause dam-age to the headlamp system. <
参考になったと評価
5人が参考になったと評価しています。
その他の取扱説明書
32999 view
11929 view
42906 view
3536 view
28670 view
もっと見る