MINIの取扱説明書・マニュアル [全174ページ 2.96MB]
ownersmanual2010hardtopconvertible.pdf
gizport - 2013-09-05
http://libraryofmotoring.info/.../ownersmanual2010hardtopconvertible.pdf - 2.96MB
- キャッシュ
6966view
174page / 2.96MB
REFERENCE AT A GLANCE CONTROLS DRIVING TIPS MOBILITY 131>Filling the tire with sealant>Distribute the sealant>Correct the tire inflation pressureFilling the tire with sealantProceed in the specified order; otherwise, sealant may emerge under high pres-sure.<1.Shake the sealant bottle.2.Pull the connection hose 9 out of the com-pressor housing fully and screw it onto the connector of the sealant bottle. Make sure that the hose is not kinked.3.Insert the sealant bottle on the compressor housing in an upright position.4.Unscrew the dust cap from the valve of the defective wheel and screw the filling hose 2 of the sealant bottle onto the valve.5.Ensure that the compressor is switched off.6.Insert the plug 3 into the lighter socket/power socket in the vehicle interior, page88.7.With the engine running: Switch on the compressor and let is run for approx. 3 to 8 minutes to fill the tire with sealant and achieve a tire inflation pressure of approx. 26 psi/180 kPa.When filling the tire with sealant, the inflation pressure can briefly rise to approx. 73 psi/500 kPa. Do not switch off the compressor during this phase. <Do not run the compressor for longer than 10 minutes; otherwise, the device will overheat and possibly be dam-aged.<8.Switch off the compressor.If an air pressure of 26 psi/180 kPa is not reached:1.Unscrew the filling hose 2 from the wheel and drive the vehicle forward and backward approx. 33 ft/10 m to distribute the liquid sealant in the tire evenly.2.Inflate the tire again with the compressor.If an inflation pressure of 26 psi/180 kPa still cannot be reached, the tire is too heavily damaged. Please contact the nearest MINI dealer.<Stowing Mobility System1.Unscrew filler hose 2 of the sealant bottle from the wheel.2.Unscrew connecting hose of the compressor9 from the sealant bottle.3.Connect the filler hose 2 of the sealant bot-tle to the unoccupied connection on the sealant bottle.This prevents the rest of the sealant from escaping from the bottle.4.Wrap the empty sealant bottle in suitable material to avoid dirtying the cargo bay.5.Stow Mobility System back in the vehicle.Distributing the sealantImmediately drive approx. 3 mls/5 km to evenly distribute the sealant.Do not exceed speeds of 50 mph/80 km/h.If possible, do not drop below 10 mph/20 km/h.<Correcting the tire inflation pressure1.After driving approx. 3 mls/5 km or ten min-utes, stop at a suitable location.2.Screw the connection hose 2 of the com-pressor directly onto the tire valve.3.Insert the plug 3 into the power socket in the vehicle interior.4.Correct the inflation pressure to 26 psi/180 kPa. With the engine running:
参考になったと評価
5人が参考になったと評価しています。
その他の取扱説明書
33789 view
12137 view
43474 view
3622 view
28967 view
もっと見る