MINIの取扱説明書・マニュアル [全172ページ 3.02MB]
ownersmanual2011clubman.pdf
gizport - 2013-09-05
http://libraryofmotoring.info/.../ownersmanual2011clubman.pdf - 3.02MB
- キャッシュ
32750view
172page / 3.02MB
131AT A GLANCE REFERENCE MOBILITY CONTROLS DRIVING TIPS COMMUNICATIONS3.Disconnect the cable connector if necessary, arrow1.4.Unscrew the corresponding bulb counter-clockwise, arrow2, and remove it.5.To insert the new bulb and reinstall the tail lamp, proceed in reverse order.Rear fog lamps*/Reverse lightsBulbs 16 Watt, W 16WThe rear fog lamp is located in the left tail lamp, refer to Tail lamps page 130.<License plate lamps5 watt bulb, C 5 W1.Using a screwdriver, push the lamp to the left in the tab of the lamp housing, arrow 1.2.Remove the lamp, arrow 2.3.Replace the bulb.4.Insert the lamp.Center brake lampThis lamp uses LED technology for operation. In the event of a malfunction, contact your MINI dealer or a workshop that has specially trained personnel working in accordance with the spec-ifications of your MINI manufacturer.Repairing a flat tireSafety measures in the event of a break-down: Park the vehicle as far as possible from moving traffic and switch on the hazard warning flash-ers.Turn the steering wheel until the front wheels are in the straight-ahead position and engage the steering wheel lock. Engage the parking brake and shift into 1st or reverse gear or place the selector lever in position P.All passengers should be outside the vehicle and in a safe place, e.g. behind a guardrail.Erect a warning triangle or warning flasher at the appropriate distance if necessary. Comply with all safety guidelines and regulations. <In the event of a flat tire, different procedures should be followed depending on the equip-ment included in your vehicle:>MINI Mobility System, refer to the following section>Run-flat tires, page 115>Tire change with space-saver spare tire, page134MINI Mobility System with onboard vehicle tool kit and tire change set*PreparationsUse of the MINI Mobility System may be ineffec-tive if the tire puncture measures approx. 1/8 in/4 mm or more. Contact the nearest MINI dealer if the tire cannot be made drivable with the Mobility System.Do not remove foreign bodies which have pen-etrated the tire if possible.Follow the instructions on using the Mobil-ity System found on the compressor and the sealant bottle. <Remove the adhesive label for the speed limit from the sealant bottle and affix it to the steer-ing wheel.The Mobility System with tire change set and onboard vehicle tool kit is located under the floor mat or the flat load floor in the cargo area.
参考になったと評価
10人が参考になったと評価しています。
その他の取扱説明書
11846 view
42658 view
3490 view
28497 view
36672 view
もっと見る