MINIの取扱説明書・マニュアル [全172ページ 3.02MB]
ownersmanual2011clubman.pdf
gizport - 2013-09-05
http://libraryofmotoring.info/.../ownersmanual2011clubman.pdf - 3.02MB
- キャッシュ
33004view
172page / 3.02MB
61AT A GLANCE REFERENCE MOBILITY CONTROLS DRIVING TIPS COMMUNICATIONSUsing the button in the turn signal lever1.Start the engine, but do not start driving.2.Briefly press the button in the turn signal lever repeatedly until "SET/INFO" is dis-played.3.Press and hold the button until the display changes.4.Briefly press the button repeatedly until the symbol for Tire Pressure Monitor and "ACTIVE" are displayed.The Tire Pressure Monitor can be reset by selecting "RESET".5.Press and hold the button until "RESETTING" is displayed.6.Start driving.After driving a few minutes, the set inflation pressures in the tires are accepted as the tar-get values to be monitored. The system reset is completed during your drive, and can be interrupted at any time. When driving resumes, the reset is continued automati-cally. The indicator lamp goes out after the system reset is completed.Message for low tire inflation pressureThe warning lamps come on in yellow and red. An acoustic signal also sounds. The position of the faulty tire is dis-played.>There is a flat tire or substantial loss of tire pressure.>The system was not reset after a wheel change and thus issues a warning based on the inflation pressures initialized last.1.Reduce speed and stop the vehicle with cau-tion. Avoid sudden braking and steering maneuvers.2.Check whether the vehicle is equipped with normal tires or with run-flat tires*.Run-flat tires, refer to page 115, are identi-fied by a circular symbol containing the let-ters RSC on the tire sidewall.When a low inflation pressure is reported, the Dynamic Stability Control DSC is activated.Actions in the event of a flat tireNormal tires1.Identify the damaged tire.To do so, check the inflation pressure in all four tires. The inflation pressure display of the Mobility System, refer to page 131, can be used for this.If the inflation pressure is correct in all four tires, then the Tire Pressure Monitor may not have been reset. The system must then be reset.If it is not possible to identify the damaged tire, contact your MINI center.
参考になったと評価
10人が参考になったと評価しています。
その他の取扱説明書
11935 view
42913 view
3538 view
28679 view
36857 view
もっと見る