MINIの取扱説明書・マニュアル [全172ページ 3.02MB]
ownersmanual2011clubman.pdf
gizport - 2013-09-05
http://libraryofmotoring.info/.../ownersmanual2011clubman.pdf - 3.02MB
- キャッシュ
33004view
172page / 3.02MB
77AT A GLANCE REFERENCE MOBILITY CONTROLS DRIVING TIPS COMMUNICATIONS5.To program other original hand-held trans-mitters, repeat steps 3 and 4.The corresponding memory button 1 is now programmed with the signal of the original hand-held transmitter.You can operate the system with the engine running or with the ignition switched on.If the system fails to function even after repeated programming, check whether the original hand-held transmitter uses an alter-nating-code system. To do so, either read the instructions for the original hand-held transmit-ter or hold down th e programmed memory button1 of the integrated universal remote con-trol. If the LED2 on the integrated universal remote control flashes rapidly and then remains lit for about two seconds, the original hand-held transmitter uses an alternating-code system. If it uses an alternating-code system, program the memory buttons1 as described under Alternat-ing-code hand-held transmitters. <Alternating-code hand-held transmittersTo program the integrated universal remote control, consult the operating instructions for the device to be set. You will find information there on the possibilities for synchronization or programming of additional hand-held transmit-ters.When programming hand-held transmitters that employ an alternating code, please observe the following supplementary instructions:Programming will be easier with the aid of a second person.<1.Park your vehicle within the range of the remote-controlled device.Do not exceed a distance of 50 m from the radio remote controlled device.2.Program the integrated universal remote control as described above in the section Fixed-code hand-held transmitters.3.Locate the button on the receiver of the device to be set, e.g. on the drive unit.4.Press the button on the receiver of the device to be set. After step 4, you have approx. 30 seconds for the next step 5.5.Press the programmed memory button 1 of the integrated universal remote control three times.The corresponding memory button 1 is now programmed with the signal of the original hand-held transmitter.Clearing stored programsPress both outer memory buttons 1 for approx. 20 seconds until the LED 2 flashes: all stored programs are cleared.It is not possible to clear individual programs.Reassigning individual programs1.Hold the original hand-held transmitter at a distance of approx. 2 in to 12 in/5 to 30 cm from the memory buttons 1.The required distance between the hand-held transmitter and the mem-ory buttons1 depends on the system of the respective original hand-held transmitter used.<2.Press the desired memory button 1 of the integrated universal remote control.3.If the LED 2 flashes slowly after approx. 20 seconds, press the transmit key of the original hand-held transmitter and release both buttons as soon as the LED 2 flashes rapidly.If the LED 2 does not flash rapidly after approx. 15 seconds, alter the distance and repeat this step.
参考になったと評価
10人が参考になったと評価しています。
その他の取扱説明書
11935 view
42913 view
3538 view
28679 view
36857 view
もっと見る