1. 取扱説明書・マニュアル >
2. MINI >
3. 自動車 >
4. MINI の使い方、故障・トラブル対処法 >
5. MINI の取扱説明書・マニュアル

MINIの取扱説明書・マニュアル [全172ページ 3.02MB]

Wheels and tires114meet under the Federal Motor Vehicle Safety Standard No. 109. Grades B and A represent levels of performance on the laboratory test wheel that exceed the minimum required by law.The temperature grade for this tire is established for a tire that is properly inflated and not overloaded. Excessive speed, underinflation, or excessive loading, either separately or in combination, can cause heat buildup and possible tire failure. <RSC - run-flat tires*You will recognize run-flat tires by a circular symbol containing the letters RSC on the side of the tire, page115.M+SWinter and all-season tires. These have better winter properties than sum-mer tires.XLDesignation for specially reinforced tires.Tire conditionInspect your tires regularly for tread wear, signs of damage and for foreign objects lodged in the tread. Check the tread depth.Tread depthThe tread depth should not drop below 1/8 in/3 mm, although, for example, European legis-lation only specifies a minimum tread depth of 1/16 in/1.6 mm. At tread depths below 1/8 in/3 mm there is an increased risk of high-speed hydroplaning, even when only small amounts of water are present on the road surface.Winter tiresWhen winter tires wear down past a tread depth of 1/6 in/4 mm, they become perceptibly less suitable for winter conditions. In the interest of safety, new tires should be installed.Minimum tread depthWear indicators in the ba se of the tread groove are distributed around the tire's circumference; the letters TWI, for Tread Wear Indicator, on the tire's sidewalls identify tires that incorporate these wear indicators. When tire tread is worn down to the level of the wear indicators, the remaining tread depth is 1/16 in/1.6 mm.Tire damageDue to low-profile tires, please note that wheels, tires and suspensions parts are more susceptible to road hazards and consequential damages.Unusual vibrations encountered during normal vehicle operation can indicate tire failure or some other vehicle defect. This can, for exam-ple, be caused by driving over curbs. The same applies to any other abnormal road behavior, such as pulling severely to the right or left.In these cases, reduce speed immediately and have wheels and tires thoroughly checked. To do so, drive carefully to the nearest MINI dealer or tire shop that works according to MINI repair procedures with correspondingly trained personnel. If necessary, have the vehicle towed there. Otherwise, tire damage can be extremely dan-gerous for vehicle occupants and other road users.<Tire ageThe manufacturing date of tires is contained in the tire coding: DOT ... 3010 means that the tire was manufac-tured in week 30 of 2010.For various reasons, such as the development of brittleness, the manufacturer of your MINI

もっと見る

このマニュアルの目次

Copyright © 2013 Gizport.jp All Rights Reserved.