X3の取扱説明書・マニュアル [全126ページ 4.65MB]
123807.pdf
gizport - 2013-09-06
http://153.127.246.254/.../123807.pdf - 4.65MB
- キャッシュ
20989view
126page / 4.65MB
ReferenceAt a glanceControlsDriving tipsMobility 95Replacing componentsOnboard tool kit The onboard tool kit is located in a compart-ment on the left in the cargo area. Replacing wiper blades Front1.Move the wiper into the fold-out position, refer to page38.2.Lift the wiper arm and press the securing spring, refer to arrow. 3.Pull the wiper blade off toward the wiper arm. 4.Insert the new blade and snap it into place.Fold the wipers back down onto the wind-shield before you turn the ignition key to position 1 or 2 again. If you do not, they could be damaged.< Rear 1.Lift the wiper arm. 2.Pull off the wiper blade, refer to arrow. 3.Insert a new wiper blade.Lamps and bulbs The lamps and bulbs make essential contribu-tions to the safety of your vehicle. Therefore, comply fully with the following instructions dur-ing bulb replacement. If you are not familiar with the specified procedures, BMW recommends having the replacements carried out at your BMW Sports Activity Vehicle Center. Never touch the glass of new bulbs with your bare fingers, as even minute amounts of contamination will burn into the bulb's surface and reduce its service life. To install, use a clean cloth, napkin etc. or hold the bulb by its metal socket. <A replacement bulb set is available from your BMW Sports Activity Vehicle Center.To prevent short circuits, before working on any electrical system, equipment or accessory you should always switch it off and disconnect the cable from the battery's nega-tive terminal before starting.To avoid possible injury or equipment damage when replacing bulbs, observe any instructions provided by the bulb manufacturer. < When maintaining the headlamps, please comply with the instructions in the sepa-rate Caring for your vehicle brochure. <
参考になったと評価
5人が参考になったと評価しています。
その他の取扱説明書
53119 view
26085 view
20837 view
23008 view
22105 view
もっと見る