X3の取扱説明書・マニュアル [全126ページ 4.65MB]
123807.pdf
gizport - 2013-09-06
http://153.127.246.254/.../123807.pdf - 4.65MB
- キャッシュ
21235view
126page / 4.65MB
Practical interi or accessories62Practical interior accessoriesIntegrated universal remote control* The concept The integrated universal remote control replaces up to three different hand-held trans-mitters for various items of radio-controlled equipment such as door openers and house alarm systems. The integrated universal remote control recognizes and learns the transmitted signal of each of the original hand-held trans-mitters. The signal of an original hand-held transmitter can be programmed on one of the three mem-ory buttons1. Once this is done, each of the devices can be actuated with the appropriately programmed memory button 1. The indicator lamp 2 confirms transmission of the signal. Should you sell your vehicle one day, be sure to delete the stored programs beforehand for your safety, refer to page 63. To prevent possible damage or injury, before programming or using the inte-grated universal remote control, always inspect the immediate area to make certain that no peo-ple, animals or objects are within the travel range of the device. Also, comply with the safety precautions of the original hand-held transmitter.< Checking compatibility If you see this symbol on the packaging or in the manual supplied with the orig-inal hand-held transmitter, it is safe to assume that it is compatible with the integrated universal remote control.If you have additional questions, please consult your BMW Sports Activity Vehicle Center or call 1-800-355-3515.You can also visit these websites:www.bmwusa.com or www.homelink.com. HomeLink is a registered trademark owned by Johnson Controls, Inc. < Programming 1Memory buttons 2Indicator lamp Fixed-code hand-held transmitters1.Turn the ignition key to position 2.2.For initial use: Press both outer buttons 1 for approx. 20 seconds, maintaining pressure until the indicator lamp2 starts to flash. The three memory buttons1 are cleared.3.Hold the original hand-held transmitter at a distance of approx. 2 in/5 cm to 8 in/20 cm from the memory buttons 1.The required distance between the hand-held transmitter and memory buttons1 depends on the relevant system of the original hand-held transmitter used. <4.Simultaneously press the transmit button on the original hand-held transmitter and the desired memory button 1 of the inte-grated universal remote control. Initially, the indicator lamp2 flashes slowly. Release both buttons as soon as the indicator lamp2 flashes rapidly. If the indicator lamp2 does not flash rapidly after approx. 15 seconds, change the distance. 5.To program other original hand-held trans-mitters, repeat steps 3 and 4.
参考になったと評価
5人が参考になったと評価しています。
その他の取扱説明書
54139 view
26385 view
21080 view
23278 view
22406 view
もっと見る