X3の取扱説明書・マニュアル [全140ページ 3.36MB]
123810.pdf
gizport - 2013-09-06
http://153.127.246.254/.../123810.pdf - 3.36MB
- キャッシュ
21868view
140page / 3.36MB
ReferenceAt a glanceControlsDriving tipsMobility 117First-aid kit*Some of the articles in the first-aid kit may be used within a limited time only. Check the expi-ration dates of the contents regularly and replace the contents in a timely fashion as needed.The first-aid kit is located under the front pas-senger's seat.To open: pull the handle and fold the cover downward.To close: fold the cover up.Jump startingWhen your battery is discharged, you can use two jumper cables to start the engine of your BMW with power from the battery in another vehicle. You can also use the same method to help start another vehicle. Use only jumper cables with fully-insulated clamp handles.To avoid the risk of potentially fatal injury, always avoid all contact with electrical components while the engine is running. Care-fully comply with the following instructions to avoid personal injury and/or damage to one or both vehicles.<Preparing1.Check whether the battery of the other vehicle has a voltage of 12 Volts and approximately the same capacitance in Ah. This information can be found on the bat-tery.2.Switch off the engine of the vehicle provid-ing assistance.3.Switch off any electrical systems and com-ponents in both vehicles.Ensure that there is no contact between the bodywork on the two vehicles; other-wise, there is a danger of short circuits. <Connecting jumper cablesConnect the jumper cables in the correct order; failure to do so could generate sparks and cause injury. <In your BMW, the so-called jump starting termi-nal in the engine compartment functions as the positive battery terminal, also refer to engine compartment overview on page 101. The symbol + is embossed on the cover.1.Open the cover of the BMW jump starting terminal, refer to arrow 1.2.Connect one terminal clamp of the posi-tive/+ jumper cable to the positive terminal of the battery or to a jump starting terminal of the vehicle providing starting assistance.3.Connect the second terminal clamp of the positive/+ jumper cable to the positive ter-minal of the battery or to a jump starting ter-minal of the vehicle to be started.4.Connect one terminal clamp of the nega-tive/- jumper cable to the negative terminal of the battery or to an engine or body ground of the vehicle providing assistance.Your BMW has a special nut that serves as the body ground or ne gative terminal, refer to arrow2.5.Connect the second terminal clamp of the negative/- jumper cable to the negative ter-minal of the battery or to the engine or body ground of the vehicle to be started.
参考になったと評価
5人が参考になったと評価しています。
その他の取扱説明書
53910 view
26349 view
21061 view
21216 view
23259 view
もっと見る