1. 取扱説明書・マニュアル >
2. BMW >
3. 自動車 >
4. X3 の使い方、故障・トラブル対処法 >
5. X3 の取扱説明書・マニュアル

X3の取扱説明書・マニュアル [全140ページ 3.36MB]

Technology for comfort, convenience and safety50Technology for comfort, convenience and safetyPDC Park Distance Control*The conceptPDC provides extra safety and convenience during parking maneuvers. Audible signals indi-cate that you are approaching an object in front of or behind your vehicle. To measure the dis-tance, there are four ultrasonic sensors in each bumper. An acoustic signal begins to sound when the front sensors and the rear corner sensors are within approx. 2 ft/60 cm of an obstacle and when the rear middle sensors are within approx. 5 ft/1.50 m of an obstacle.PDC is a parking aid that can indicate objects when they are approached slowly, as is usually the case when parking. Avoid approaching objects too fast; otherwise, the system may give warning of physical obsta-cles too late.<If you are driving with a trailer, the rear sensors cannot take any meaningful measurements. Consequently, they do not switch on.Automatic modeIn ignition key position 2, the system is auto-matically activated after approx. 1 second each time you shift into reverse or move the selector-lever into position R. Wait for one second to pass before moving.You can have a signal tone programmed into the system to verify that the PDC is active.<Activating manual modeIn ignition key position 2, press the button; the LED lights up.Deactivating manual modePress the button again, the LED goes out.The system is automatically deactivated once the vehicle travels approx. 160 ft/50 m or exceeds a speed of roughly 20 mph/30 km/h; the LED goes out. You can reactivate the sys-tem manually as needed.Signal tonesAn intermittent tone from a rear speaker signals the distance to an object behind the vehicle as you approach it.An intermittent tone from a speaker beneath the dashboard signals the distance to an object in front of the vehicle as you approach it.As the distance between vehicle and object decreases, the intervals between the tones become shorter. The signal tone becomes con-tinuous once the distance to the nearest object falls to below roughly 1 ft/30 cm.An intermittent tone is interrupted after approx. 3seconds:>If you remain in front of an object that is only detected by one of the corner sensors>If you are moving parallel to a wall

もっと見る

このマニュアルの目次

Copyright © 2013 Gizport.jp All Rights Reserved.