81.0 OWNER’S MANUALcongratulations with your new ine speakers. please read this manual thoroughly before unpacking and installing your new speakers to get the most out of your purchase. You can ind more information on our website: www.dali.dk or by contacting your authorized DALI dealer.2.0 UNPACKINGBe careful not to damage the contents when you unpack the parts. check that all parts are contained in the cardboard box, see table 1. Keep the packaging materials should your speaker need to be relocated or serviced.3.0 MAINTENANCEcleaning the speaker surfaces can be done with ordinary household cleaning agents. Avoid using products that are abrasive, or contain acid, alkali or anti-bacterial agents. Avoid using aerosols. Avoid using cleaning agents directly on the drive units and clean them with extreme care, particularly the tweeter. the grille fabric may be cleaned using a vacuum cleaner or a normal clothes brush.4.0 AVOID DIRECT SUNLIGHTthe surfaces of the speakers may fade over time when exposed to direct sunlight. therefore avoid positioning the speakers in direct sunlight.5.0 ENVIRONMENTAL INFORMATION AND DISPOSALDALI products are designed to meet the international directives concerning Restriction of Hazardous Substances (RoHS) and disposal of Waste Electrical and Electronic Equipment (WEEE). the waste symbol indicates that the speakers meet the directives, see Figure 1. the speakers must be processed or recycled appropriately. please consult your local waste authority for guidance.6.0 RUNNING-INYou should expect the sound quality from your new speakers to gradually improve during the irst period of use. Nothing particular has to be done in order to run in the speakers – but expect up to 100 hours of playback (depending on playback level) before full performance level is reached.7.0 SPEAKER SETUP AND POSITIONING7.1 LEKTOR 1/2/3/LCRthe speakers can be positioned on a stand/shelf or hung on a wall using the integrated wall bracket(s). If positioned on a stand or shelf, the enclosed rubber bumpers can be mounted under the speaker for stable and vibration free positioning, see Figure 2A. If hung on a wall, mount the bumpers on the rear edge of the speakers, see Figure 2B. the speakers are hung on a wall using one or two screw(s) mounted in the wall. the screw(s) must it the wall bracket(s) on the rear side of the speaker, see Figure 2c. LEKtOR LcR can be hung vertically if used as left/right/rear speaker, or horizontally if used as center channel speaker. If used as an on-wall center channel, two screws must be used to hang the speaker, see Figure 2D.
