115) “crossover” adjustment: adjust the overlap between the subwoofer and the main speakers by adjusting “crossover” up and down until you hear the bass is smooth and without “holes”. You may need to readjust the Volume setting (4) slightly after this adjustment.6) “phase” switch, 0° or 180°: adjust subwoofer phase to match the main speakers in the speaker setup – try both settings to determine which setting sounds best. It might be necessary to readjust both Volume level (4) and crossover (5) again.7) Mains cable connector: check that the voltage written below the mains connect matches your mains voltage.8) Fuse compartment: If the subwoofer does not power up, check that the fuse in the fuse compartment is not blown. If blown, replace the fuse with the same type as the original. If the fuse blows multiple times, have your subwoofer serviced at an authorized service facility.9) “power” switch: powers the subwoofer on or off. p ower off the subwoofer if it is not used for extended periods. Always power off the subwoofer when changing connection(s).10) Heat sink: do not cover! caution - can be hot!to connect the subwoofer to your stereo or surround sound system, please consult the owner’s manual for your stereo/surround sound ampliier to locate a subwoofer output terminal or a pre-out output terminal. the subwoofer must be connected to the ampliier using a RcA cable (sold separately).there are two primary connection options:A) Connect the subwoofer to a stereo ampliier • connect the output terminal(s) of the stereo ampliier to the “Line Input L + R” connectors on the subwoofer ampliier.B) Connect the subwoofer to a surround sound ampliier• connect the subwoofer/LFE output terminal on the surround sound ampliier to “LFE Input” terminal on the subwoofer ampliier.12.0 TECHNICAL SPECIFICATIONSIn table 2 (see page 24) you will ind most common speciications for our speakers. please do remember, that the sound quality from a speaker cannot be judged by technical speciications. to compare the different speakers, we recommend you to listen to the different speakers in question.
