Setting up your Logitech® X-530 speakersImportant: For your safety, set up the system before plugging it into a power source.1. Before attaching the cables to the subwoofer, position the two front satellite speakers on either side of your computer monitor about the same distance from each other as from you. Angle them to face you. The right front speaker is the control center for your system, so you will want to place it within easy reach. Place the rear left and right satellite speakers behind you and about the same distance apart as the front speakers. Position the front center channel speaker on top of your monitor or on your desk in between your monitor and keyboard. Depending on where you place your speakers, adjust the stand to direct the sound toward you. For best sound quality, place the subwoofer on the floor beneath your desk. Be sure to maintain at least 6 inches of spacing around the subwoofer to allow for adequate ventilation.2. Insert the colored plug from each satellite speaker into the corresponding colored jacks on the back of the subwoofer. Connect the d-sub plug from the front right speaker to the subwoofer as shown on the previous page. Carefully align the pins before inserting the plug, and screw down the connector.3. A. If you have a PC and a:• 6, 7 or 8 channel (5.1, 6.1 or 7.1) sound card: Connect all 3 colored plugs from the audio input cable to the color-coded jacks on the sound card. 1. If jacks on your soundcard are not color coded, plug the audio input as follows: • green to front L/R (or #1) • black to rear L/R (or #2) • orange to center / sub (or #3)• 4-channel sound card: Connect the green plug from the audio input cable to your sound card’s front jack and the black plug to your sound card’s rear jack. Do not use the orange plug.• 2-channel sound card: Connect the green plug from the audio input cable to the “line out” jack on your sound card. Do not use the black or orange plugs. With a 2-channel sound card you will not hear sound from the rear speakers. B. If you have a video game console (PlayStation®, PlayStation®2, Xbox™, or GameCube®):• Connect the green, black and orange plugs from the audio input cable to the 3 stereo mini jacks on the video game adapter. • Connect the red and white RCA audio cables from your video game console to the RCA audio jacks to the video game adapter. 4. Plug the subwoofer’s power cord into an electrical outlet.Enjoying your Logitech® X-530 speakersAccess these controls on the right front speaker:Power/StandbyToggles between power on and standby mode.System VolumeAdjusts the overall system volume.Headphone JackWhen headphones are used with your X-530 system, the speakers will mute automatically for private listening. Headphone volume is controlled by the soundcard on your computer.Dolby® DigitalThe X-530 speakers support Dolby® Digital sound on your PC if your 6-channel or greater sound card or DVD software can decode a Dolby® Digital soundtrack.Subwoofer VolumeLocated on the subwoofer. Use to adjust subwoofer volume (bass level).Mounting your speakers to the wallYour Logitech X-530 speaker satellites are wall mountable. Swivel the satellite base to desired position, and use the notch to hang your speaker on appropriate wall anchors.Specifications• Total RMS Power: 70.1 Watts Subwoofer: 25 watts RMS into 4 ohms at 100Hz at 10% THD clipping (total harmonic distortion) Satellites: 45.1 watts RMS (2 x 7.4 w Front; 15.5 w Center: 2 x 7.4 w Rear ) into 4 ohms at 1 kHz at 10% THD clipping (total harmonic distortion)• Total Peak Power: 140 Watts at <10% THD• System THD: Better than 0.07% THD before clipping• Signal to noise ratio: >99 dB• Frequency response: 40 Hz - 20 kHz• Driver Size: 2” high excursion satellites, 5.25” high excursion subwoofer• Speaker dimensions: Satellites: (H) 8” x (W) 2.5” x (D) 3” Center: (H) 2.5” x (W) 8” x (D) 3” Subwoofer: (H) 11.5” x (W) 6” x (D) 9.25” SetupSetup - Operation - Specifications4English3EnglishNotch
