1. 取扱説明書・マニュアル >
2. ライカ >
3. カメラ >
4. カメラ本体 >
5. 一眼レフカメラ >
6. Leica M7 の使い方、故障・トラブル対処法 >
7. Leica M7 の取扱説明書・マニュアル

Leica M7の取扱説明書・マニュアル [全134ページ 1.37MB]

77Loading the film0 5. Hold the film cartridge in the right hand andinsert it about half-way into the empty chamberNote: The cartridge is pushed past the spring-loaded DX contacts during loading. The principleof this means that you will feel slight resistance.0 6. Take the film leader and pull it until it is in thetake up spool (35) as shown in the schematicdiagram (33) on the inside of the camera housing, and0 7. carefully press the film cartridge and the filmleader into the camera with your fingertips.Notes: • The film leader must be trimmed as is the casewith all ready to use films. • If the film leader is pulled so far out that it pro-trudes slightly from one of the slits on the op-posite side of the take up spool; this does noaffect the functioning of the camera. It is only infrosty conditions that the film must be insertedexactly as shown in the schematic drawing, i.e.the film leader may only be taken up by one sliton the take up spool so that the protr uding endof the film cannot be broken off.Important!Correct film transportation should notbe checked with the camera open, as the base pla-te is designed in such a way that replacing it on thecamera guides the film into the correct position.Closing the camera0 8. Replace the camera back,0 9. hook the base plate onto the retaining pin onthe side of the camera (1),10. return the base plate to its normal position,ensuring that the camera back is completelypressed against it so that it is enclosed by thebase plate, and11. lock using the latch.

このマニュアルの目次

Copyright © 2013 Gizport.jp All Rights Reserved.