1. 取扱説明書・マニュアル >
2. DELL >
3. パソコン >
4. パソコン本体 >
5. ノートパソコン >
6. Inspiron 1525 の使い方、故障・トラブル対処法 >
7. Inspiron 1525 の取扱説明書・マニュアル

Inspiron 1525の取扱説明書・マニュアル [全51ページ 1.51MB]

Back to Contents Page  Processor ModuleDell™ Inspiron™ 1525/1526 Service Manual  Removing the Processor Module CAUTION: Before you begin the following procedure, follow the safety instructions in the Product Information Guide.1. Follow the instructions in Before You Begin.2. Remove the processor thermal-cooling assembly (see Removing the Processor Thermal-Cooling Assembly).NOTICE: To avoid damage to the processor, hold the screwdriver so that it is perpendicular to the processor when turning the cam screw.3. To loosen the ZIF socket, use a small, flat-blade screwdriver and rotate the ZIF-socket cam screw counterclockwise until it comes to the cam stop.1 ZIF-socket cam screw 2 ZIF socketNOTICE: To ensure maximum cooling for the processor, do not touch the heat transfer areas on the processor thermal-cooling assembly. The oils inyour skin can reduce the heat transfer capability of the thermal pads.NOTICE: When removing the processor module, pull the module straight up. Be careful not to bend the pins on the processor module.4. Lift the processor module from the ZIF socket. Replacing the Processor Module CAUTION: Before you begin the following procedure, follow the safety instructions in the Product Information Guide.NOTICE: Do not touch the processor die. Press and hold the processor down on the substrate on which the die is mounted while turning the cam screwto prevent intermittent contact between the cam screw and processor.NOTICE: Ensure that the cam lock is in the fully open position before seating the processor module. Seating the processor module properly in the ZIFsocket does not require force. A processor module that is not properly seated can result in an intermittent connection or permanent damage to themicroprocessor and ZIF socket.NOTE: If a new processor is installed, you will receive a new thermal-cooling assembly, which will include an affixed thermal pad, or you will receive anew thermal pad along with a tech sheet to illustrate proper installation.1. Align the pin-1 corner of the processor module with the pin-1 corner of the ZIF socket, then insert the processor module.NOTE: The pin-1 corner of the processor module has a triangle that aligns with the triangle on the pin-1 corner of the ZIF socket.

このマニュアルの目次

Copyright © 2013 Gizport.jp All Rights Reserved.