Vostro 1510の取扱説明書・マニュアル [全62ページ 1.36MB]
vostro-1510_service%20manual_en-us.pdf
gizport - 2013-08-21
ftp://ftp.dell.com/.../vostro-1510_service%20manual_en-us.pdf - 1.36MB
- キャッシュ
17557view
62page / 1.36MB
Back to Contents Page Processor ModuleDell™ Vostro™ 1510 Service Manual Removing the Processor Module Replacing the Processor Module Removing the Processor Module CAUTION: Before you begin the following procedure, follow the safety instructions that shipped with your computer.1. Follow the instructions in Before Working on Your Computer.2. Loosen the two screws that secure the memory cover. (See Removing a Memory Module for an illustration of the memory cover.)3. Slide the cover out of the compartment and set it aside.4. Remove the fan (see Removing the Fan).5. Remove the processor thermal-cooling assembly (see Removing the Processor Thermal-Cooling Assembly). NOTICE: To avoid damage to the processor, hold the screwdriver so that it is perpendicular to the processor when turning the cam screw.6. To loosen the ZIF socket, use a small, flat-blade screwdriver and rotate the ZIF-socket cam screw counterclockwise until it comes to the cam stop.1 ZIF-socket cam screw 2 ZIF socket NOTICE: To ensure maximum cooling for the processor, do not touch the heat transfer areas on the processor thermal-cooling assembly. The oilsin your skin can reduce the heat transfer capability of the thermal pads. NOTICE: When removing the processor module, pull the module straight up. Be careful not to bend the pins on the processor module.7. Lift the processor module from the ZIF socket. Replacing the Processor Module CAUTION: Before you begin the following procedure, follow the safety instructions that shipped with your computer. NOTICE: Do not touch the processor die. Press and hold the processor down on the substrate on which the die is mounted while turning the camscrew to prevent intermittent contact between the cam screw and processor.
参考になったと評価
5人が参考になったと評価しています。
その他の取扱説明書
27208 view
852 view
1541 view
720 view
1102 view