1. 取扱説明書・マニュアル >
2. DELL >
3. パソコン >
4. パソコン本体 >
5. ノートパソコン >
6. Precision M6300 の使い方、故障・トラブル対処法 >
7. Precision M6300 の取扱説明書・マニュアル

Precision M6300の取扱説明書・マニュアル [全138ページ 5.05MB]

24 Quick Reference Guide NOTE: If you see a message stating that no diagnostics utility partition has been found, run the Dell Diagnostics from the Drivers and Utilities media.The computer runs the Pre-boot Syst em Assessment (PSA), a series of initial tests of your system board, keyb oard, display, memory, hard drive, etc. During the assessment, answer any questions that appear. If failures are detected durin g the Pre-boot System Assessment, write down the error code(s) and then contact Dell (see "Contacting Dell" in your User's Guide ).If the Pre-boot System Assessment completes successfully, the following message appears: "Booting Dell Diagnostic Utility Partition. Press any key to continue."4 Press any key to start the Dell Diagnostics from the diagnostics utility partition on your hard drive.5 When the Dell Diagnostics Main Menu a ppears, select the test you want to run (see "Dell Diagnostics Main Menu" on page 25).Starting the Dell Diagnostics From the Drivers and Utilities Media1 Insert the Drivers and Utilities media .2 Shut down and restart the computer.When the DELL logo appears, press <F12> immediately. NOTE: If you wait too long and the operatin g system logo appears, continue to wait until you see the Microsoft Win dows desktop, then shut down your computer and try again. NOTE: The next steps change the boot sequence for o ne time only. On the next start up, the computer boots acco rding to the devices specified in the system setup program.3 When the boot device list appears, highlight CD/DVD/CD-RW and press <Enter>.4 Select the Boot from CD-ROM option from the menu that appears and press <Enter>.5 Type 1 to start the CD menu a nd press <Enter> to proceed.

このマニュアルの目次

Copyright © 2013 Gizport.jp All Rights Reserved.