Check that your supply corresponds to that shown on the rating plate. Theappliance must only be used as rated, and it should be fitted with an approved fuse to BS1362. This appliance is supplied with a moulded three pin mains plug for your safety and convenience. A 13 amp fuse is fitted in this plug. Should thefuse need to be replaced, please ensure that the replacement fuse has a rating of 13 amps and that it is approved by ASTA or BSI to BS1362. Check for the ASTAmark or the BSI mark on the body of the fuse. If the plug contains a removablefuse cover you must ensure that it is refitted when the fuse is replaced. If you losethe fuse cover, the plug must not be used until a replacement cover is obtained. A replacement fuse cover can be purchased from your local Dyson dealer.If the fitted moulded plug is unsuitable for the socket outlet in your home then thefuse should be removed and the plug cut off and disposed of safely. There is adanger of severe electrical shock if the cut off plug is inserted into any 13 ampsocket.If a new plug is to be fitted, please observe the wiring code as shown below. If inany doubt please consult a qualified electrician.The wires in this mains lead are coloured in accordance with the following code:BLUE : Neutral BROWN : LiveAs the colours of the wire in the mains lead of this appliance may not correspondwith the coloured markings identifying the terminals in your plug, proceed asfollows:1. The wire which is coloured BLUE must be connected to the terminal in the plugwhich is marked with the letter N or coloured BLACK.2. The wire which is coloured BROWN must be connected to the terminal in theplug which is marked with the letter L or coloured RED.Under no circumstances should either of these wires be connected to the earthterminal of the three pin plug, marked with the letter E or the Earth Symbol orcoloured GREEN or GREEN and YELLOW.Always ensure that the cable clamp is fitted and that it clamps the cable outer andNOT the coloured wires.How to replace the fuse:1. Open the fuse compartment with a screwdriver. 2. Replace the fuse and fuse cover if detachable.If the supply cable of the appliance is damaged, disconnect the appliance from thesocket outlet immediately; the supply cable must be replaced. This should be carriedout by Dyson Appliances Ltd only or its appointed agent, as special purpose toolsand service techniques are required.A sample of product has been tested and found to be in conformity with the following European Directives:Should you find one day that your product needs replacement, or is of no furtheruse to you, think of the protection of the environment. Contact the Dyson Helplineto recycle your cleaner. The cleaner ' s plastic parts will be sorted, cleaned, re-cleaned,separated, granulated, dyed and re-moulded. The re-cycled parts will then go tomake new, Dyson Recyclone cleaners - the world ' s first recycled vacuum cleaner. Important safety instructions*Do not leave the vacuum cleaner plugged into the mains socket outlet. Unplug from the outlet when not in use and before cleaning the appliance, and before maintenance operations.*Ensure that hands, feet and fingers, particularly of small children are kept away from the cleaner and especially from the brushbar. If hanging the cleaner by the storage hook, ensure it is securely fixed and out of the way of children and pets. Never allow children to play with or use this appliance.*Do not use without the bin assembly fitted correctly and both filters in place.Do not fit anything other than Dyson spare parts. This could invalidate your guarantee (Call the Dyson Helpline on 0990 275104).*Do not carry out any maintenance work on the cleaner other than that outlined in this manual, especially where electrical components are concerned.*Ensure that the brushbar is off when cleaning smooth floors to avoid marking. If carpet pilling occurs, either use the cleaner with brushbar on to remove, or contact the carpet retailer.*Static charges can occur in the clear bin when vacuuming certain carpets. These are entirely harmless and are not associated with the mains supply. To minimise any effect, do not put your hand or insert any object into the clear bin unless you have first emptied and rinsed out the clear bin with water. If wiping dust from the shroud, use a brush or a damp cloth.*Do not use the cleaner if the cable or plug are damaged or if the machine has been damaged, dropped or has come into contact with water or any other liquids. In these cases, contact the Dyson Helpline on 0990 275104.*Do not put any part of the body, clothes or any object near or into the openings or moving parts of the machine. Do not use the machine with any of the openings blocked with an object that may restrict the air flow.*Do not damage the cable by running the cleaner head over it, closing a door on it or running it over sharp edges. Do not put the cable near or on hot surfaces. If the cable is damaged, call the Dyson Helpline.*Always stand above the machine when cleaning on the stairs.*Do not, under any circumstances, use the cleaner to pick up water or any other liquid. Electrical shocks could occur if used outdoors or on wet surfaces.*Do not use the cleaner or handle the plug with wet hands.*Do not use the machine to pick up flammable or combustible substances and do not use near such substances. Never pick up asbestos or asbestos dust or poisonous solids, such as copier toner.*Do not use the machine to pick up hot ashes or burning objects of any kind.*Do not immerse the whole machine in water for cleaning. The clear bin alone may be washed out after emptying. Do not remove bin inner and seals. Ensure it is completely dry before re-using the cleaner.*Do not use the cleaner near open or gas fires when they are lit.*Turn the machine off by the switch button before unplugging from a mains outlet.*When carrying the cleaner, use only the carrying handle positioned immediately below the on/off switch.73/23/EEC Low Voltage (Safety)Directive93/68/EEC CE Marking DirectiveWHEN USING THE DYSON DC03 VACUUM CLEANERPLEASE ADHERE TO THESE SIMPLE PRECAUTIONSBy doing so you will reduce the risk of fire, electrical shock or injury.PLEASE READ CAREFULLY BEFORE USEIMPORTANTEUROPEAN CONFORMITY INFORMATIONUNWANTED PRODUCTS AND THE ENVIRONMENT
