Inspiron Zinoの取扱説明書・マニュアル [全53ページ 1.08MB]
inspiron-zino_Service%20Manual_en-us.pdf
ftp://ftp.dell.com/.../inspiron-zino_Service%20Manual_en-us.pdf - 1.08MB
- キャッシュ
8934view
53page / 1.08MB
Back to Contents Page Processor Heat Sink (Inspiron 400 Only)Dell™ Inspiron™ 300/400 Service Manual Removing the Processor Heat Sink Replacing the Processor Heat SinkWARNING: Before working inside your computer, read the safety information that shipped with your computer. For additional safety bestpractices information, see the Regulatory Compliance Homepage at www.dell.com/regulatory_compliance.WARNING: The heat sink may be very hot during normal operation. Be sure that it has had sufficient time to cool before you touch it. CAUTION: Only a certified service technician should perform repairs on your computer. Damage due to servicing that is not authorized by Dell™ is not covered by your warranty. CAUTION: To avoid electrostatic discharge, ground yourself by using a wrist grounding strap or by periodically touching an unpainted metalsurface (such as a connector on your computer). CAUTION: Do not perform the following steps unless you are familiar with hardware removal and replacement. Performing these stepsincorrectly could damage your system board. For technical service information, see the Setup Guide. Removing the Processor Heat Sink1. Follow the procedures in Before You Begin.2. Remove the top cover (see Removing the Top Cover).3. Remove the top bracket (see Removing the Top Bracket).4. Remove the optical drive (see Removing the Optical Drive).5. Remove the drive bay (see Removing the Drive Bay). CAUTION: To ensure maximum cooling for the processor, do not touch the heat transfer areas on the processor heat sink. The oils in your skincan reduce the heat transfer capability of the thermal grease.6. In sequential order (indicated on the processor heat sink), loosen the four captive screws in descending order that secure the processor heat sink tothe system board.7.8.1 Carefully lift the processor heat sink away from the computer. Lay the processor heat sink down on its top, with the thermal grease facing upward.processor heat sink2captive screws (4) Replacing the Processor Heat Sink
参考になったと評価
2人が参考になったと評価しています。