Inspiron Zinoの取扱説明書・マニュアル [全53ページ 1.08MB]
inspiron-zino_Service%20Manual_en-us.pdf
ftp://ftp.dell.com/.../inspiron-zino_Service%20Manual_en-us.pdf - 1.08MB
- キャッシュ
8934view
53page / 1.08MB
1cutouts (2)2tab3notch4memory-module connector5memory module 3. Insert the memory module into the connector until the memory module snaps into position.If you insert the memory module correctly, the securing clips snap into the cutouts at each end of the memory module. If the securing clips do not snapinto position, remove the memory module and reinstall it.NOTE: If the memory module is not installed properly, the computer may not boot.1cutouts (2)2securing clips (2) (snapped in position)4. Replace the drive bay (see Replacing the Drive Bay).5. Replace the optical drive (see Replacing the Optical Drive).6. Replace the top bracket (see Replacing the Top Bracket).7. Replace the top cover (see Replacing the Top Cover). CAUTION: Before turning on the computer, replace all screws and ensure that no stray screws remain inside the computer. Failure to do so mayresult in damage to the computer.8.9.10. Connect your computer and all attached devices to electrical outlets, and then turn them on.If the message appears stating that memory size has changed, press <F1> to continue. Log on to your computer. To verify that the memory is installed correctly:Windows® XP:Click Start® Control Panel® System.Windows Vista®:Click the Start button® Control Panel® System and Maintenance.Windows 7:Click the Start button11.® Control Panel® System and Security® System. Check the amount of memory (RAM) listed. Inspiron 400 Removing the Memory Module(s)1. Follow the procedures in Before You Begin.2. Remove the bottom cover (see Removing the Bottom Cover). CAUTION: To prevent damage to the memory module connector, do not use tools to spread the memory module securing clips.
参考になったと評価
2人が参考になったと評価しています。