LC-37GD3の取扱説明書・マニュアル [全227ページ 24.43MB]
lc37gd3_ope.pdf
gizport - 2013-10-03
http://www.sharp.co.jp/.../lc37gd3_ope.pdf - 24.43MB
- キャッシュ
23240view
227page / 24.43MB
214Quick Start GuideInserting batteries in theremote controlOpen the battery cover.1Insert the supplied two AAAbatteries, and close the cover.2Gently holding down the -marked area, slide the cover in the direction of the arrow.Make sure that the terminals match the and indications in the battery compartment.Cautions regarding batteriesImproper use of batteries can result inchemical leakage or explosion. Be sure tofollow the instructions below.* Do not mix batteries of different types.* Do not mix old and new batteries.* Do not try to charge or disassemblebatteries.* Place the batteries with their terminalscorresponding to the ± and — indications.* Do not short-circuit batteries.* The supplied batteries may have a shorter lifeexpectancy due to storage conditions.Replace them with new ones before they aredepleted.* Remove the batteries from the remote control,if you will not use it for a long time.* If, after replacing batteries, the remote controldoes not work, make sure the new batteriesare placed in the right direction.NotePart Names - Remote Control UnitRemote control operating rangeWhen operating the remote control, direct its head towardthe remote sensor window located at the bottom rightcorner of the display unit, as shown below. The maximumoperating range is approximately 7 meters in distance,and 30 degrees in angle against the straight line normalto the remote sensor window, as shown below.Note:»The remote control may not work when there is anobstacle between the remote control and the displayunit's remote sensor window.»As the batteries are depleted, the operating distancewill become shorter. Replace them with new ones.»The remote control may not work properly when there isa fluorescent light near the display unit's remote sensorwindow.CAUTIONCautions regarding the remote control* Do not expose the remote control to shock, water, orhigh humidity.* The remote sensor window on the display unit may notproperly receive remote control signals when it isunder direct sunlight or strong lighting. In such a case,change the angle of the lighting or the display unit.30° 30° Remote sensor window7mLC-37GD3(S)_210-226 2004.6.25, 2:51 PM Page 214 Adobe PageMaker 6.5J/PPC
参考になったと評価
9人が参考になったと評価しています。
その他の取扱説明書
459 view