1. 取扱説明書・マニュアル >
2. 東芝 >
3. パソコン >
4. パソコン本体 >
5. ノートパソコン >
6. dynabook Satellite B550 B の使い方、故障・トラブル対処法 >
7. dynabook Satellite B550 B の取扱説明書・マニュアル

B550 Bの取扱説明書・マニュアル [全189ページ 7.44MB]

170付 録Notes for Users in Australia and New ZealandModem warning notice for AustraliaModems connected to the Australian telecoms network must have a valid Austel permit. This modem has been designed to speciically conigure to ensure compliance with Austel standards when the region selection is set to Australia.The use of other region setting while the modem is attached to the Australian PSTN would result in you modem being operated in a non-compliant manner.To verify that the region is correctly set, enter the command ATI which displays the currently active setting. To set the region permanently to Australia, enter the following command sequence:AT%TE=1ATS133=1AT&FAT&WAT%TE=0ATZFailure to set the modem to the Australia region setting as shown above will result in the modem being operated in a non-compliant manner. Consequently, there would be no permit in force for this equipment and the Telecoms Act 1991 prescribes a penalty of $12,000 for the connection of non-permitted equipment.Notes for use of this device in New Zealand- The grant of a Telepermit for a device in no way indicates Telecom acceptance of responsibility for the correct operation of that device under all operating conditions. In particular the higher speeds at which this modem is capable of operating depend on a specific network implementation which is only one of many ways of delivering high quality voice telephony to customers. Failure to operate should not be reported as a fault to Telecom.- In addition to satisfactory line conditions a modem can only work properly if: a/ it is compatible with the modem at the other end of the call and b/ the application using the modem is compatible with the application at the other end of the call - e.g., accessing the Internet requires suitable software in addition to a modem.- This equipment shall not be used in any manner which could constitute a nuisance to other Telecom customers.- Some parameters required for compliance with Telecom's PTC Specifications are dependent on the equipment (PC) associated with this modem. The associated equipment shall be set to operate within the following limits for compliance with Telecom Speciications: a/ There shall be no more than 10 call attempts to the same number within any 30 minute period for any single manual call initiation, and b/ The equipment shall go on-hook for a period of not less than 30 seconds between the end of one attempt and the beginning of the next. c/ Automatic calls to different numbers shall be not less than 5 seconds apart.4技術基準適合について

このマニュアルの目次

Copyright © 2013 Gizport.jp All Rights Reserved.