Aspire 3820
x
Gizport

Aspire 3820の取扱説明書・マニュアル [全11ページ 0.16MB]

5
101759.pdf
Swan2911 - 2013-08-16
http://153.127.246.254/.../101759.pdf - 0.16MB - キャッシュ
4619view
11page / 0.16MB
Share (facebook)
8 / 11 ページ
 
8 / 11 ページ
ファイルを開く
現在のページURL
UN Test Data (Model:3UR18650-3-T0664)1.Test Item: Shock (T4) P.6/102.Test Purpose: This test simulates possible impacts during transport.3.Test Procedure: Test cells and batteries shall be secured to the testing machine by means of a rigid mount which will support all mounting surfaces of each test battery. Each cell or battery shall be subjected to a half-sine shock of pack acceleration of 150 g n and pulse duration of 6 milliseconds. Each cell or battery shall be subjected to three shocks in the positive direction followed by three shocks in the negative direction of three mutually perpendicular mounting positions of the cell or battery for a total of 18 shocks. However, large cells and large batteries shall be subjected to a half-sine shock of peak acceleration of 50 g n and pulse duration of 11 milliseconds. Each cell or battery is subjected to three shocks in the positive direction followed by three shocks in the negative direction of each of three mutually perpendicular mounting positions of the cell for a total of 18 shocks. SANYO Internal Procedure: As above.4.Test Requirements: No mass loss(less than 0.1%),no leakage,no venting,no disassembly,no rupture and no fire,and the voltage retention is not less than 90%. The requirement relating to voltage is not applicable to test batteries at fully discharged states.5.Test Date: 2008/12/156.Test DataBefore test After test Before test After test1 490.56 490.60 0.01 12.65 12.64 99.90PASS2 491.32 491.34 0.00 12.64 12.63 99.90PASS3 490.65 490.66 0.00 12.64 12.63 99.90PASS4 490.86 490.87 0.00 12.65 12.64 99.90PASS5 491.16 491.12 0.010PASS6 491.53 491.52 0.000PASS7 490.62 490.66 0.010PASS8 490.65 490.64 0.000PASS9 491.47 491.48 0.00 12.56 12.56 100.00PASS10 490.58 490.55 0.01 12.56 12.56 100.00PASS11 490.92 490.95 0.01 12.56 12.56 100.00PASS12 491.22 491.20 0.00 12.56 12.56 100.00PASS13 491.27 491.26 0.000PASS14 491.82 491.84 0.000PASS15 491.15 491.14 0.000PASS16 491.21 491.18 0.010PASSNotes: L-Leakage, V-Venting, D-Disassembly, R-Rupture, F-Fire, 0-No leakage, no venting, no disassembly, no rupture & no fireResultJudgement At firstcycle,infullychargedstatesPASSAt firstcycle,infullydischargedstatesAfter 50cyclesending infullychargedstatesAfter 50cyclesending infullydischargedstatesBattery No.Mass(g)Massloss (%)(=<0.1%)Voltage(V)VoltageRetention(%)(=>90%)Otherevent

参考になったと評価
  6人が参考になったと評価しています。

その他の取扱説明書
3098 view
816 view
868 view
324 view
247 view
もっと見る

このマニュアルの目次

  • 1 .
    Name of SampleConsignorM...
    Name of SampleConsignorManufacturerTest MethodCriterionAppearanceTest DateSample NumberTest ItemsConclusionUnited Nations "Recomenndations on the TRANSPORT OF DANGEROUS GOODS"Black rectangular parallelepiped2008/11/20 - 2008/12/1924Altitude simulation, Th...
  • 2 .
    Presence ofchange----T2:T...
    Presence ofchange----T2:Thermal Shock  (Repetition of high temp.and low temp.)・Crimped part, Gasket (Cell)・Gas Release Vent, Cell Case (Cell)・Finished state of Wound Electrodes (Cell)・Pack (Plastic) Case・Holding Member(Insulator, Insulation Tape, Both Side...
  • 3 .
    (Manual of Tests and Cri...
    (Manual of Tests and Criteria ST/SG/AC.10/11/Rev.4, PartIII,sub-section 38.3)7.56 gAS10E36May.27.2010Nominal voltageWatt-hour rating Lithium ion battery Specification:::Customer Model For battery onlyFor cell onlyE1004664PassPassPassPassPassPassPass−S...
  • 4 .
    7.56 gAS10E36May.27.2010...
    7.56 gAS10E36May.27.2010Nominal voltageWatt-hour rating Lithium ion battery Specification:::Customer ModelE1004664Sanyo Product CodeSanyo ModelF138608043UR18650-3-T0664Certificate of Package Drop Test for Lithium ion battery11.1 V94 Wh
  • 5 .
    UN Test Data (Mod...
    UN Test Data (Model:3UR18650-3-T0664)1.Test Item: Altitude simulation (T1) P.3/102.Test Purpose: This test simulates air transport under low-pressure conditions.3.Test Procedure: Test cells and batteries shall be stored at a pressure of 11.6kPa...
  • 6 .
    UN Test Data (Mod...
    UN Test Data (Model:3UR18650-3-T0664)1.Test Item: Thermal Test (T2) P.4/102.Test Purpose: This test assesses cell and battery seal integrity and internal electrical connections. The test is conducted using rapid and extreme temperature changes...
  • 7 .
    UN Test Data (Mod...
    UN Test Data (Model:3UR18650-3-T0664)1.Test Item: Vibration (T3) P.5/102.Test Purpose: This test simulates vibration during transport.3.Test Procedure: Cells and batteries are firmly secured to the platform of the vibration machine without disto...
  • 8 .
    UN Test Data (Mod...
    UN Test Data (Model:3UR18650-3-T0664)1.Test Item: Shock (T4) P.6/102.Test Purpose: This test simulates possible impacts during transport.3.Test Procedure: Test cells and batteries shall be secured to the testing machine by means of a rigid mount...
  • 9 .
    UN Test Data (Mod...
    UN Test Data (Model:3UR18650-3-T0664)1.Test Item: External short circuit (T5) P.7/102.Test Purpose: This test simulates an external short circuit.3.Test Procedure: The cell or battery to be tested shall be temperature stabilized so that its exte...
  • 10 .
    UN Test Data (Mod...
    UN Test Data (Model:3UR18650-3-T0664)1.Test Item: Impact (T6) P.8/102.Test Purpose: This test simulates an impact.3.Test Procedure: The test sample cell or component cell is to be placed on a flat surface. A 15.8mm diameter bar is to be placed ac...
  • 11 .
    UN Test Data (Mod...
    UN Test Data (Model:3UR18650-3-T0664)1.Test Item: Overcharge (T7) P.9/102.Test Purpose: This test evaluates the ability of a rechargeable battery to withstand an overcharge condition.3.Test Procedure: The charge current shall be twice the manufac...