1. 取扱説明書・マニュアル >
2. パナソニック >
3. パソコン >
4. パソコン周辺機器 >
5. プロジェクタ >
6. PT-VX400 の使い方、故障・トラブル対処法 >
7. PT-VX400 の取扱説明書・マニュアル

PT-VX400の取扱説明書・マニュアル [全80ページ 12.77MB]

SettingENGLISH - 53SettingsXSubpicture size JPress ▲▼ to select [Subpicture size] 1 ) and then press the <SELECT> button.Press ▲▼ to select one among the 2 ) items as below.You can change the subpicture size among zSmall, Middle and Large.Subpicture position JPress ▲▼ to select [Subpicture 1 ) position] and then press the <SELECT> button.Press ▲▼ to select one among the 2 ) positions as below.You can adjust the subpicture position. (the zbottom right, the top right, the top left and the bottom left).Attention[Subpicture size] and [Subpicture position] works only zunder P IN P mode.The P IN P function is not available depending on the zinput signals and the selected input terminals.When the input signal(s) is/are incompatible, mark will zbe displayed on the Main/Sub picture.Power managementFor reducing power consumption as well as maintaining the lamp life, the Power management function turns off the projection lamp when the projector is not operated for a certain period.Press ▲▼ to select [Power 1 ) management].Press ► or the <SELECT> button to 2 ) access the submenu.Mode JPress ▲▼ and then press the 1 ) <SELECT> button to select one mode among the items as below.ReadyWhen the lamp has been fully cooled down, the <POWER> indicator changes to green blinking. In this condition, the projection lamp will be turned on if the input signal is reconnected or any button on the control panel or remote control is pressed.Shut downWhen the lamp has been fully cooled down, the power will be turned off.Off[Power management] function is off.Timer JPress ▲▼ to select [Timer] and then 1 ) press the <SELECT> button.Press ▲▼ to set the Timer(1~30min). 2 ) Direct onPress ▲▼ to select [Direct on] and 1 ) then press the <SELECT> button.Press ▲▼ to switch between On and 2 ) Off.When this function is set to [On], the projector zwill be automatically turned on just by connecting the AC power cord to a wall outlet.Be sure to turn off the projector properly. If the zprojector is turned off in the incorrect sequence, the [Direct On] function does not work properly.Standby modeThis function can set the electric power when the projector is standing by.Press ▲▼ to select [Standby mode] 1 ) and then press the <SELECT> button.Press ▲▼ to switch between the items 2 ) as below.EcoRestricts some functions in standby mode to reduce power consumption.NetworkDoes not restrict functionality even in standby mode.NoteWhen selecting [Network], the cooling fans may be zrunning depending on the temperature inside the projector even if the projector is turned off.Refer to "Operating Instructions - Network Operations z".If Standby mode is set to [Eco], you cannot use network zfunctions when the projector is standing by. Also, you cannot use some RS-232C protocol commands.If set to [Network], you can use network functions when zthe projector is standing by.

このマニュアルの目次