1. 取扱説明書・マニュアル >
2. カメラ >
3. カメラ本体 >
4. 一眼レフカメラ >
5. 一眼レフカメラ 全般 の使い方、故障・トラブル対処法 >
6. 一眼レフカメラ 全般 の取扱説明書・マニュアル

Leica M7の取扱説明書・マニュアル [全134ページ 1.37MB]

124ViewfinderViewfinder principle Large, bright-line viewfinder with auto-matic parallax compensation.Eyepiece Set for –0.5 dptr. Corrective lenses from –3 to +3 dptr.availableFraming Projection of pairs of bright-line frames: For 28 and90mm (90mm frame only on LEICA M7 0.85) or for 35 and135mm (35mm frame only on LEICA M7 0.58) or for 50 and75mm. Automatic projection with the lens fitted. The desired frame can be projected using the frame selector.Parallax compensation Automatic compensation of horizontaland vertical viewfinder/lens parallax according to the focusingsetting, i.e. the viewfinder bright-line frame aligns automaticallywith the subject in the lens. Correspondence of image in viewfinder and on film Thebright-line frame corresponds to a 23 x 35mm image for each focal length set to its shortest distance. At infinity, the film frame, depending on the focal length covers approx. 9% (28mm)to 20% (135mm) more than shown in the corresponding bright-line frame.Magnification (for all lenses) LEICA M7 0.58: 0.58x, LEICA M7 0.72: 0.72x, LEICA M7 0.85: 0.85x. Wide-base rangefinder Bright split-image and double-image rangefinder in center of viewfinder image.Effective base width LEICA M7 0.58: 40.2mm (mechanicalbase width 69.25mm x viewfinder magnification 0.58x), LEICA M7 0.72: 49.9mm (mechanical base width 69.25mm x viewfinder magnification 0.72x), LEICA M7 0.85: 58.9mm (mechanical base width 69.25mm x viewfinder magnification 0.85x).DisplaysIn the viewfinder (lower edge) LED symbol for flash status. Four-digit, seven segment digital LED display, display brightness adjusted to outside brightness, with decimal point and raiseddot for giving film speeds, warning for exposure compensations,automatically calculated shutter speed in aperture priority mode, indication of the use of metering memory-lock, warningfor working above or below the measuring range in aperture priority mode and course of shutter speeds slower than 2s.LED light balance with two triangular and one central circularLED for manual exposure setting. Triangular LEDs show the re-quired direction of rotation for both the aperture setting ring andthe shutter speed dial.On top plate Frame counter.On rear Dial with DX positions for automatic reading of filmspeeds or manual setting of film speed and exposure compen-sation.Shutter and release mechanismShutter Rubberised-cloth horizontal-run, focal plane shutter; extremely low-noise operation. Electronically controlled, with 2mechanically controlled shutter speeds of 1/60s and 1/125s.Shutter speeds With aperture priority mode (" AUTO "), conti-nuous from 32s to 1/1000s. With manual setting 4s to1/1000s in whole steps, " B " for long exposures of any duration, (1/50s) for flash synchronisation.Shutter release Three-step: Power – Metering memory-lock(for aperture priority mode) – Release. Integrated standardthread for cable release.

このマニュアルの目次

Copyright © 2013 Gizport.jp All Rights Reserved.