CTの取扱説明書・マニュアル [全38ページ 1.40MB]
sec_03-07.pdf
http://drivers.lexus.com/.../sec_03-07.pdf - 1.40MB
- キャッシュ
3218view
38page / 1.40MB
4543-7. Other interior featuresCT200h_U (OM76004U)nProgramming a rolling code system (for U.S.A. owners)If your device is rolling code eq uipped, follow the steps under the heading "Programming HomeLink(R)" before proceeding with the steps listed below.Locate the training button on the ceiling mounted garage door opener motor. The exact location and color of the button may vary by brand of garage door opener motor.Refer to the operation manual supplied with the garage door opener for the location of the training button.Press the training button.Following this step, you have 30 se conds in which to initiate step 3 below.Press and hold the vehicle's programmed HomeLink(R) button for 2 seconds and release it. Repeat this step once again. The garage door may open.If the garage door opens, the programming process is complete. If the door does not open, press and release the button a third time. This third press and release will complete the programming process by opening the garage door.The ceiling mounted garage door op ener motor should now recognize the HomeLink(R) signal and operate the garage door.Repeat the steps above to prog ram another rolling code system for any of the remaining HomeLink(R) buttons.STEP 1STEP 2STEP 3STEP 4
参考になったと評価
3人が参考になったと評価しています。
その他の取扱説明書
39918 view
2014 view
17408 view
752 view
8770 view
もっと見る