541-3. Opening, closing and locking the doorsCT200h_U (OM76004U)nAlarms and warning indicatorsA combination of exterior and interior al arms as well as warning messages shown on the multi-information display is used to prevent theft of the vehicle and accidents resulting from erroneous operation. Take appropriate measures in response to any warning message on the multi-information display. ( →P. 593)The following table describes circumstances and correction procedures when only alarms are sounded. nSecurity feature→P. 62nBattery-saving functionThe battery-saving function will be activa ted in order to prevent the electronic key battery and the 12-volt battery from being discharged while the vehicle is not in operation for a long time.lIn the following situations, the smart ac cess system with push-button start may take some time to unlock the doors.* The electronic key has been left in an area of approximately 6 ft. (2 m) of the outside of the vehicle for 10 minutes or longer.* The smart access system with push-but ton start has not been used for 5 days or longer.Alarm Situation Correction procedureExterior alarm sounds once for 10 seconds.An attempt was made to lock the vehicle while a door was open.Close all of the doors and lock the doors again.Interior alarm pings repeatedlyThe "POWER" switch was turned to ACCESSORY mode while the driver's door was open (The driver's door was opened when the "POWER" switch was in ACCESSORY mode.)Turn the "POWER" switch off and close the driver's door.
