GSの取扱説明書・マニュアル [全41ページ 0.84MB]
sec_03_07.pdf
http://drivers.lexus.com/.../sec_03_07.pdf - 0.84MB
- キャッシュ
3813view
41page / 0.84MB
3363-7. Other interior featuresn Programming a Rolling Code system (for U.S.A. owners)If your device is Rolling Code equipped, follow the steps under the heading "Programming the HomeLink®" before proceeding with the steps listed below.Locate the training button on the ceiling mounted garage door opener motor. The exact location and color of the button may vary by brand of garage door opener.Refer to the operation manual supplied with the garage door opener for the location of the training button.Press the training button.Press and release the vehicle's programmed HomeLink® button twice. The garage door may open.If the garage door opens, the programming process is complete. If the door does not open, press and release the button a third time. This third press and release will complete the programming process by opening the garage door.The ceiling mounted garage door opener motor should now recognize the HomeLink® transceiver and operate the garage door.Repeat the steps above to program another rolling code system for any of the remaining HomeLink® buttons.n Programming an entry gate (for U.S.A. owners)/Programming all devices in the Canadian marketPlace your transmitter 1 to 3 in. (25 to 75 mm) away from the sur -face of the HomeLink®.Keep the indicator light on the HomeLink® in view while programming.Press and hold the selected HomeLink® button.Repeatedly press and release (cycle) the device's remote control button for two seconds each until step 4 is complete.When the indicator light on the HomeLink® compatible trans -ceiver start to flashing rapidly, release the buttons.STEP 1STEP 2STEP 3STEP 4STEP 1STEP 2STEP 3STEP 4
参考になったと評価
3人が参考になったと評価しています。
その他の取扱説明書
14546 view
1702 view
7245 view
1579 view
12486 view
もっと見る