AIR CONDITIONING2752010 HS250h Navigation from July.09 Prod.(OM75015U)15AUTO button 276. . . . . . . . . . . . 16PASSENGER TEMP buttons(Passenger side temperature controlbutton) (Only for the independent mode thatdisplay shows DUAL; mainly forfront passenger and secondarily fordriver) 276, 278. . . . . . . . . . . . . . . . . 17TEMP buttons(Driver side temperature control but-ton) (At the independent mode thatdisplay shows DUAL; mainly fordriver and secondarily for front pas-senger)(At the linked mode that display doesnot show DUAL; for driver)276, 278 . . . . . . . . . . . . . . . . . . . . . . . ∗: Plasmacluster technology is manufac-tured under license from the SHARPCorporation. Plasmacluster is atrademark of the SHARP Corporation.(a) Climate controlAir outlets and fan speed are automati-cally adjusted according to the temper-ature setting.The POWER switch must be in ONmode.Push the MENU button and selectClimate to display the air condition-ing control screen.INFORMATIONWhen the POWER switch isturned on, the air conditioning sys-tem settings will be set to thosethat were in use the last time thePOWER switch was turned off.Air conditioning system settingsare memorized individually oneach electronic key, so the settingsreproduced will be specific to thekey that is used.To reduce potential odors from oc-curring:It is recommended that the airconditioning system be set tooutside air mode prior to turn-ing the vehicle off.The start timing of the blowermay be delayed for a short peri-od of time immediately after theair conditioning system isstarted in automatic operationmode.
