ISの取扱説明書・マニュアル [全14ページ 0.77MB]
3
14 / 14 ページ
現在のページURL
1662-2. Instrument clusterCAUTION■The information display at low temperaturesAllow the interior of the vehicle to warm up before using the liquid crystal informa-tion display. At extremely low temperatures, the information display monitor mayrespond slowly, and display changes may be delayed. For example, there is a lag between the driver's downshifting and the new gearnumber appearing on the display. In this case, wait until the display changes andtake care not to downshift again, causing rapid and excessive engine braking andpossibly an accident resulting in death or serious injury.
参考になったと評価 
3人が参考になったと評価しています。
このマニュアルの目次
-
1 .1532When driving2-2. Inst...1532When driving2-2. Instrument clusterGauges and metersThe units used on the speedometer an d the tachometer gauge display maydiffer depending on the model/type. The following gauges, meters and display illuminate when the"ENGINE START STOP" switch is in...
-
2 .1542-2. Instrument cluste...1542-2. Instrument clusterInstrument panel light controlThe brightness of the instrument panel lights can be adjusted. DarkerBrighterOdometer and trip meterOdometer: Displays the total distance the vehicle has been driven.Trip meter: Displays the distance ...
-
3 .1552-2. Instrument cluste...1552-2. Instrument cluster2When drivingSpeed and tacho indicators■Turning the indicator on/offBring up the satellite switch modeon the multi-information display.Press " <", " >" or the "ON/OFF"button.Select the item whose setting is tobe changed.Press " <"...
-
4 .1562-2. Instrument cluste...1562-2. Instrument cluster■Changing the indicator settingThe satellite switch can be used to change the set speed at which theyellow speed or tacho indicator ring comes on.The setting can be made only when the "ENGINE START STOP"switch is in IGNITION ON m...
-
5 .1572-2. Instrument cluste...1572-2. Instrument cluster2When drivingPush " <" or " >" within 6 seconds of the speedometer or tachometer nee-dle moving to change the setting of the desired speed, then turn the indi-cator mode to "ON" by pushing the "ON/OFF" button.Pushing and holding ...
-
6 .1582-2. Instrument cluste...1582-2. Instrument clusterNOTICE■To prevent damage to the engine and its components●Do not let the indicator needle of the ta chometer enter the red zone, which indi-cates the maximum engine speed.●The engine may be overheating if the temperature gauge is ...
-
7 .1592-2. Instrument cluste...1592-2. Instrument cluster2When drivingIndicators and warning lightsThe indicator and warning lights on the instrument cluster and centerpanel inform the driver of the status of the vehicle's various systems. Instrument clusterThe units used on the speedom...
-
8 .1602-2. Instrument cluste...1602-2. Instrument cluster■IndicatorsThe indicators inform the driver of th e operating state of the vehi-cle's various systems. *1: These lights turn on when the "ENGINE START STOP" switch isturned to IGNITION ON mode to indicate that a system check isbei...
-
9 .1612-2. Instrument cluste...1612-2. Instrument cluster2When drivingCAUTION■If a safety system warning light does not come onShould a safety system light such as the ABS and SRS warning light not come onwhen you start the engine, this could mean that these systems are not available t...
-
10 .1622-2. Instrument cluste...1622-2. Instrument clusterMulti-information displayThe multi-information display presents the driver with a variety of driving-related data, including the current outside air temperature. ●Trip information (→P. 163)Displays driving range, fuel con-sumption...
-
11 .1632-2. Instrument cluste...1632-2. Instrument cluster2When drivingTrip informationDisplay items can be switched bypushing the "DISP" switch. ■Outside temperature■Driving range Displays the outside air temperature. The temperature range that can be displayed is from-40°F (-40°C) to 1...
-
12 .1642-2. Instrument cluste...1642-2. Instrument cluster■Average fuel consumption ■Average fuel consumption after refueling ■Current fuel consumption ■Average vehicle speed Displays the average fuel consumption since thefunction was reset. * The function can be reset by pushing the "DI...
-
13 .1652-2. Instrument cluste...1652-2. Instrument cluster2When driving■Gear position displayIndicates the current gear, and the range of gearsthat is available when the shift lever is in the D or Sposition. The gear range is shown by the number ofdots (•) and the current gear is shown a...
-
14 .1662-2. Instrument cluste...1662-2. Instrument clusterCAUTION■The information display at low temperaturesAllow the interior of the vehicle to warm up before using the liquid crystal informa-tion display. At extremely low temperatures, the information display monitor mayrespond slowly...
