ISの取扱説明書・マニュアル [全19ページ 0.68MB]

1 .

902-1. Driving proceduresDriving the vehicleThe following procedures should be observed to ensure safe driving. nStarting the engine (→P. 98)nDrivingAutomatic transmissionWith the brake pedal depressed, shift the shift lever to D. (→P. 101)Release the park...

2 .

912-1. Driving procedures2When drivingStarting on a steep uphillAutomatic transmissionFirmly set the parking brake and shift the shift lever to D. Gently depress the accelerator pedal. Release the parking brake. Manual transmissionWith the parking brake fi...

3 .

922-1. Driving proceduresnBreaking in your new LexusTo extend the life of the vehicle, the following precautions are recommended toobserve:lFor the first 186 miles (300 km):Avoid sudden stops.lFor the first 621 miles (1000 km):* Do not drive at extremely h...

4 .

932-1. Driving procedures2When drivingCAUTIONlIf the smell of exhaust is noticed inside the vehicle, open the windows and checkthat the trunk is closed. Large amounts of exhaust in the vehicle can cause driver drowsiness and eventu-ally, death. Have the ca...

5 .

942-1. Driving proceduresCAUTIONlDo not drive across river crossings or through other bodies of water.This may cause electric/electronic comp onents to short circuit, damage theengine or cause other serious damage to the vehicle.nWhen shifting the shift l...

6 .

952-1. Driving procedures2When drivingCAUTIONlDo not leave the engine running in an area with snow build up, or where snow isexpected to fall. Exhaust gases may enter the vehicle and cause gas poisoning.nWhen taking a nap in the vehicleAlways turn the engi...

7 .

962-1. Driving proceduresNOTICEnWhen driving the vehiclelWith manual transmission vehicles, do not rest your foot on the clutch pedal whiledriving.Doing so may cause clutch trouble.lWith manual transmission vehicles, do no t use any gears other than the fi...

8 .

972-1. Driving procedures2When drivingNOTICEnIf you hear a squealing or scraping no ise (brake pad wear limit indicators)Have your Lexus dealer check and replac e the brake pads as soon as possible.The rotor damage can result if the pads are not replaced w...

9 .

982-1. Driving proceduresStarting the engineModes can be switched by pressing the engine switch when carrying theelectronic key on your person. (The engine can be started in any mode byoperating the switch at the same ti me as depressing the brake pedal or...

10 .

992-1. Driving procedures2When drivingnIf the engine does not startThe engine immobilizer system may not have been deactivated. ( →P. 54)nWhen the engine switch indicator flashes in amberThe system may be malfunctioning. Have the vehicle inspected by your ...

11 .

1002-1. Driving proceduresNOTICEnTo prevent battery dischargeDo not leave the engine switch in ACC or IG-ON mode for long periods withoutthe engine running.nWhen starting the engine lDo not race a cold engine.lIf the engine becomes difficult to start or st...

12 .

1012-1. Driving procedures2When drivingAutomatic Transmission (if equipped)Select a shift position appropriate for the driving conditions.nShifting the shift leverWhile the engine switchis in IG-ON mode,depress the brake pedaland move the shift lever.

13 .

1022-1. Driving proceduresnShift position uses*1: To improve fuel consumption and reduce noises, set the shift lever in the Dposition for normal driving.*2:Selecting shift ranges using S mode re stricts the upper limit of the possiblegear ranges, controls ...

14 .

1032-1. Driving procedures2When drivingChanging shift ranges in S modeShift the shift lever to the S position and operate the shift lever or shiftpaddle switch. UpshiftingDownshiftingThe initial shift range in S mode is auto matically set to 5 or 4 accordi...

15 .

1042-1. Driving proceduresnGear position display when driving in S modeThe current gear is displayed on the multi-information display. ( →P. 121)nDownshifting restrictions warning buzzer (in the S mode)To help ensure safety and driving perfor mance, downsh...

16 .

1052-1. Driving procedures2When drivingManual Transmission (if equipped)Snow modeThe snow mode is used for accel-erating and driving on slipperyroad surfaces, such as on snow. Push the switch once more toreturn to normal mode. nShifting the shift leverFull...

17 .

1062-1. Driving proceduresnRecommended shifting speedThe following table indicates shifting speeds for optimum fuel economy. mph (km/h)nMaximum downshifting speedAdhere to the downshifting speeds in the following table in order to prevent over-revving the...

18 .

1072-1. Driving procedures2When drivingTurn signal levernTurn signals can be operated whenThe engine switch is in IG-ON mode.nIf the indicators flash faster than usualCheck that a light bulb in the front or re ar turn signal lights has not burned out.Left ...

19 .

1082-1. Driving proceduresParking brakeNOTICEnBefore drivingFully release the parking brake.Driving the vehicle with the parking brake set will lead to brake components over-heating, which may affect braking performance and increase brake wear.Automatic t...