MINIの取扱説明書・マニュアル [全148ページ 3.08MB]
ownersmanual2003.pdf
gizport - 2013-09-04
http://libraryofmotoring.info/.../ownersmanual2003.pdf - 3.08MB
- キャッシュ
28507view
148page / 3.08MB
87OVERVIEW REPAIRS OPERATIONCONTROLS DATA INDEXTIRE CONDITION TIRE REPLACEMENT Tire tread/tire damage Inspect your tires frequently for tread wear, signs of damage and for foreign objects lodged in the tread. Check the tread depth.The tread depth should not fall below1/8 in / 3 mm. Below 1/8 in / 3 mm tread pattern depth, there is an increased risk of hydroplaning, even at relatively moderate speeds and with only small amounts of water on the road.Wear indicators in the tread-groove base, see arrow, are spread around the circum-ference of the tire and are marked on the side wall of the tire with TWI – Tread Wear Indicator. The indicators in the tread indi-cate at 1/16 in / 1.6 mm tread depth that the legally permitted wear limit has been reached. Never continue to drive with a flat, pressureless tire, except with Run Flat tires. A pressureless, flat tire greatly impairs steering and braking response, and can lead to complete loss of control over the vehicle. Avoid overloading the vehicle so that the permitted load on the tires is not exceeded. Overloading can lead to overheating and increases the rate at which damage develops inside the tires. The ultimate result can assume the form of a sudden air loss.Unusual vibrations while driving, caused for example by driving over a curb or simi-lar, can indicate wheel or tire damage or other damage to the vehicle. This is also true for irregularities in the vehicle's han-dling characteristics, such as a pronounced tendency to pull to the left or right. Should this occur, respond by immediately reduc-ing your speed. Proceed carefully to the nearest MINI Dealer or professional tire center, or have the vehicle towed there to have its wheels and/or tires inspected or controlled. Tire damage – up to and includ-ing blowouts – can endanger the lives of both the vehicle occupants and other road users. <To maintain good handling and vehicle response, use only tires of a single tread configuration from a single manufacturer. The manufacturer of your MINI tests and approves wheel and tire combinations.Do not use retreaded tires, since driv-ing safety may be impaired. This is due to the possible variations in casing structures and, in some cases, to their extreme age, which can lead to a decrease in their durability. <DOT quality grades Tread wear Traction AA A B C Temperature A B C All passenger car tires must conform to Federal Safety Requirements in addition to these grades. < ba.book Seite 87 Montag, 5. August 2002 8:09 20
参考になったと評価
7人が参考になったと評価しています。
その他の取扱説明書
32759 view
11858 view
42682 view
3493 view
36683 view
もっと見る