MINIの取扱説明書・マニュアル [全165ページ 2.67MB]
ownersmanual2005.pdf
gizport - 2013-09-04
http://libraryofmotoring.info/.../ownersmanual2005.pdf - 2.67MB
- キャッシュ
36857view
165page / 2.67MB
52STARTING THE ENGINESWITCHING OFF THE ENGINE Starting When starting the engine, do not press the accelerator pedal.Do not stop the starting procedure too early, and do not continue it for more than approx. 20 seconds. Release the ignition key immediately when the engine starts. Extended starting at tempts, characterized by excessively frequent or long periods with the starter engaged, can lead to dam-age in the catalytic converter. < If the engine does no t start on the first attempt, for instance if the engine is very hot or cold:When starting the engine, press the gas pedal down halfway.Cold start at very low temperatures, above approx. +5 7 / –15 6 , at high altitudes above 3,300 ft / 1,000 m:> For the initial start attempt, allow the starter to remain engaged somewhat longer, approx. 10 seconds.> When starting the engine, press the gas pedal down halfway. Manual transmission 1. Engage the parking brake 2. Put the manual gearshift lever in neutral 3. Depress the clutch pedal, especially at low temperatures4. Start the engine.Move the gearshift lever to neutral position and engage the parking brake before leaving your vehicle with the engine running. Do not leave the vehicle unattended with the engine running. This is a safety haz-ard. < Continuously Variable automatic Transmission (CVT)1. Press the footbrake 2. Put the selector lever in position P or N3. Start the engine.Move the selector lever to position P and engage the parking brake before leaving your vehicle with the engine run-ning. Do not leave the vehicle unattended with the engine running. This is a safety haz-ard. <You should never remove the ignition key when the vehicle is in motion, as the steering lock could engage. When you leave the vehicle, always remove the ignition key and engage the steering lock. When parking on inclines, engage the park-ing brake, or the vehicle could roll. < Manual transmission Turn the ignition key to position 1 or 0.Continuously Variable automatic Transmission (CVT)Engage selector lever position P, turn the ignition key to position 1 or 0.
参考になったと評価
8人が参考になったと評価しています。
その他の取扱説明書
33004 view
11935 view
42913 view
3538 view
28679 view
もっと見る