MINIの取扱説明書・マニュアル [全176ページ 2.40MB]
ownersmanual2008convertible.pdf
gizport - 2013-09-04
http://libraryofmotoring.info/.../ownersmanual2008convertible.pdf - 2.40MB
- キャッシュ
43931view
176page / 2.40MB
147OVERVIEW REPAIRS OPERATION CONTROLS DATA INDEXJUMP-STARTING TOWING AND TOW-STARTINGFlip open the cover of the auxiliary jump-starting terminal, arrow 12. Connect one terminal clamp of the plus/+jumper cable to the positive bat-tery terminal or to an auxiliary jump-starting terminal of the support vehicle3. Connect the other terminal clamp of the plus/+ jumper cable to the positive bat-tery terminal or to an auxiliary jump-starting terminal of the vehicle to be startedEngine or body ground in your MINI or MINI Convertible: arrow 2.4. Connect one terminal clamp of the minus/– jumper cable to the negative battery terminal or to an engine or body ground of the support vehicle5. Connect the second terminal clamp of the minus/– jumper cable to the nega-tive terminal of the battery or to the engine or body ground of the vehicle to be started.Performing the jump-start 1. Start the engine of the support vehicle and allow it to run at increased idle speed for several minutes2. Start the engine of the other vehicle in the usual manner. If the first start attempt is not success-ful, wait a few minutes before another attempt in order to allow the discharged battery to recharge3. Allow the engines of both vehicles to run for several minutes.On the MINI or MINI Convertible: Before disconnecting the jumper cables, switch on the lighting, the rear window defroster and the highest blower speed to prevent a voltage surge from the regulator to the electrical sys-tems and components. <4. Then disconnect the jumper cables in the reverse order.If necessary have the battery checked and completely charged at a MINI Dealer.Do not use spray starter fluids to start the engine. <Observe all applicable laws and regu-lations for towing and tow-start-ing. <Do not transport any occupant other than the driver in a vehicle that is being towed. <Using the towing eyelet The screw-in towing eyelet is stored in the onboard tool kit, refer to page 132 ; be sure that it remains with th e vehicle at all times. It can be attached at the front or rear of your vehicle.Use only the towing eyelet supplied with the vehicle and screw it in firmly until it stops. Use the towing eyelet for towing on paved roads only. Avoid subject-ing the towing eyelet to lateral loads, e.g. do not lift the vehicle using the towing eye-let. Otherwise, the towing eyelet and the vehicle could be damaged. <
参考になったと評価
7人が参考になったと評価しています。
その他の取扱説明書
33145 view
11944 view
43071 view
3557 view
28703 view
もっと見る